Restore candidate
I have this 1986 Sleekcraft enforcer that I got cheap because somebody had not paid their inside store fees for a couple years. It was a lien sale.
It is 28 feet and has twin 330hp 454's with 1.32 gear ratio alpha's. If the boat seems worth while to restore, my plan was to sell the 454's and put a couple of nice 383's with aluminum heads and aluminum exhaust to lighten the load. I have never done fiberglass work or restored a boat. I am committed to replacing the transom if needed and am willing to also replace the parts that the engines mount to if they are soft and I think they are. I am not willing to cut the floor out and replace stringers up towards the front of the boat. If it needs that, I'll part it out and then buck it up with a saw and take it to the dump. I would like to pull some wood out of a few places with a hole saw to see what I have and would like to start with the stringers because if they are bad, I am not going to go any further. I was just going to pull out like a 1 inch core and then replace with with a dowel and epoxy. My question is, are thevertical boards that make up the sides of the ski locker in the floor the stringers? They do not line up with the fiberglass covered wood that the engines mount to. Thanks, Russ https://cimg8.ibsrv.net/gimg/www.off...6ef22521b9.jpg https://cimg9.ibsrv.net/gimg/www.off...7abc429ef5.jpg https://cimg0.ibsrv.net/gimg/www.off...736b93c09a.jpg |
Not worth it. Clean it up and run it as is. Or part it out for $$, and find an old cig, fountain, formula, hustler, sutphen or velocity to restore.
|
On the question about ski locker sides being stringers, there is no way to tell without getting a look under the floor. Stringers on opposite sides of bulkheads/separate compartments do not necessarily line up with each other down the length of the boat. Engine compartment stringers very often are different from the rest of the boat to accommodate engine mounting.
|
Get that corona out of the boat........:D
|
Well spotted ^^^
|
Originally Posted by hogie roll
(Post 4733471)
Not worth it. Clean it up and run it as is. Or part it out for $$, and find an old cig, fountain, formula, hustler, sutphen or velocity to restore.
Thanks for the input. |
Get it running, clean it up and enjoy it. Definitely do no do the engine swap. Small blocks would be going backwards.
|
I have a friend who has one, with a couple of built NA 454s and -2 shorties... 90+ mph boat and handles good.
|
Alpha drives behind big blocks are a hand grenade with the pin pulled. They were a horrible combination that was (thankfully) only offered for one year. I'd pass.
|
Originally Posted by Too Stroked
(Post 4734271)
Alpha drives behind big blocks are a hand grenade with the pin pulled. They were a horrible combination that was (thankfully) only offered for one year. I'd pass.
|
All times are GMT -5. The time now is 03:57 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.