|
You are doing the front bulkhead with many pieces?
|
Two pieces split down the middle we left the original skin from the bulkhead on the frontside for strength and notched around the new stringers to give them support.
|
Cool build, impressive progress in such little time
|
|
Finally finished laying glass in the engine compartment. now the out side of the transom. and the we can start to put it back together. 12 gallons of Vinalester and about 30 yards of 1708 later
https://cimg1.ibsrv.net/gimg/www.off...09895c927e.jpg https://cimg7.ibsrv.net/gimg/www.off...b11baeacc5.jpg |
Good to see the progress !
|
Just finishing up with the outside of the transom then on to paint job
https://cimg5.ibsrv.net/gimg/www.off...d12a408011.jpg All the grinding is finally done many layers of glass and then on to the next phase. |
Great! 2-3 layers of 1708?
|
Lots of work in that transom huh Dan
|
Originally Posted by Team Archer
(Post 4727681)
Just finishing up with the outside of the transom then on to paint job
https://cimg5.ibsrv.net/gimg/www.off...d12a408011.jpg All the grinding is finally done many layers of glass and then on to the next phase. |
| All times are GMT -5. The time now is 12:05 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.