Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: itneverends
Showing results 1 to 15 of 15
Search took 0.00 seconds.
Forum: General Q & A
03-20-2012, 05:13 PM
Replies: 2
Views: 866
Posted By itneverends

454 break in

I will be putting back in my rebuilt 454 engines into boat in 2 weeks. Looking for some dos and donts when reinstalling. Any info on break in of these engines. Can Break in be done on land 55 gal...
03-20-2012, 05:01 PM
Replies: 6
Views: 887
Posted By itneverends

break in 454

I will be putting back in my rebuilt 454 engines into boat in 2 weeks. Looking for some dos and donts when reinstalling. Any info on break in of these engines. Can Break in be done on land 55 gal...
Forum: General Q & A
10-25-2011, 07:28 PM
Replies: 1
Views: 585
Posted By itneverends

454 engines

Can anyone help me out. Looking at either purchaseing 2 long block 454. or 2- 454 crate engines. checking on line found long blocks for as low as $1650.00 and as high as $9000 crate engines for as...
Forum: General Q & A
02-12-2011, 12:58 PM
Replies: 1
454
Views: 749
Posted By itneverends

454

89 reagl serial # C447909 and c447944 454 engines. cast #s are both 445. Bravo drives. Can anyone tell me horse power, which one is standard rotatition vs reverse. Any other info.
Forum: General Q & A
02-07-2011, 04:01 AM
Replies: 16
Views: 10,266
Posted By itneverends

Engines are 1989 7.4 Some told me they are 330 hp.

Engines are 1989 7.4 Some told me they are 330 hp.
Forum: General Q & A
02-06-2011, 06:42 AM
Replies: 16
Views: 10,266
Posted By itneverends

454 vs 7.4

My engines are mercruiser 7.4. I see listings for 7.4 and 454 on same sites. I always thought a 7.4 was the same as 454?
Forum: General Q & A
09-19-2010, 05:17 PM
Replies: 0
Views: 563
Posted By itneverends

advice

pulling twin 454 engines to bring in for rebuilding. Just pulling them out and putting back in myself. The rebuild will be done by a respected shop. Just looking for some dos and donts on the out and...
07-18-2010, 09:37 AM
Replies: 3
oil
Views: 894
Posted By itneverends

oil

What weight motor oil should I be using. 32 ft boat twin 454 motors. Not a speedboat. Just a heavy cruiser. We run this boat at about 3200 rpms, 30mph. Had a head gasket problem. Fixed, put some...
Forum: General Q & A
07-18-2010, 09:29 AM
Replies: 1
Views: 715
Posted By itneverends

Throttle handles

Why might my throttle handle on my starboard engine not go as far up (increase rpms) as my portside. Used to until yesterday. This causeing my rpms to be behind the portside engine. Something out of...
Forum: General Q & A
07-10-2010, 09:49 PM
Replies: 2
Views: 695
Posted By itneverends

power steering

454 engine, power steering line sprung leak while out on the water about 30 miles out today. Had new spill kit rags and pig pillows on board. Cleaned fluid best I could, and bagged all the rags. My...
Forum: General Q & A
06-26-2010, 09:53 AM
Replies: 1
Views: 618
Posted By itneverends

engine parts

Is there such a place where a person can look over and possiably buy used engine parts?
Forum: General Q & A
06-17-2010, 11:00 PM
Replies: 9
Views: 6,217
Posted By itneverends

this is great site and greatfull for any and all...

this is great site and greatfull for any and all info. I took the ps oil combo cooler out of picture. the engine still sounds great I will get this out on the bay friday and see how she runs. cracked...
Forum: General Q & A
06-17-2010, 04:07 AM
Replies: 9
Views: 6,217
Posted By itneverends

bravo drives

bravo drives
Forum: General Q & A
06-17-2010, 04:06 AM
Replies: 9
Views: 6,217
Posted By itneverends

I have two hoses coming out of power steering...

I have two hoses coming out of power steering pump. 1 to goes pump clylinder located on back of engine compartment 1 goes to steering cooler. And then a 3rd from pump clylinder to power steeing...
Forum: General Q & A
06-16-2010, 10:08 PM
Replies: 9
Views: 6,217
Posted By itneverends

water in oil 454

Iam new here. Looking for some help. 454 with water in oil. chocolate milk looking. I did have a shop look at this. Was told head gasket. I had him replace. thinking,,because dip stick is gaining ...
Showing results 1 to 15 of 15


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.