Offshoreonly.com - Search Results

Search: Posts Made By: heavyiron28

Showing results 1 to 8 of 8
Search took 0.00 seconds.

Forum: General Q & A

12-01-2012, 02:26 PM

Replies: 24

496 mag shuts off going down the lake

Views: 7,860

Posted By heavyiron28

Well I finally fixed it, I replaced the engine...

Well I finally fixed it, I replaced the engine wiring harness, have ran it for 20 hours or so and works great.

Thanks

Forum: General Q & A

08-21-2011, 09:08 PM

Replies: 24

496 mag shuts off going down the lake

Views: 7,860

Posted By heavyiron28

Thanks to everyone for all the good help! I will...

Thanks to everyone for all the good help! I will try step by step
and eliminate one by one.

Thanks

Forum: General Q & A

08-21-2011, 11:05 AM

Replies: 24

496 mag shuts off going down the lake

Views: 7,860

Posted By heavyiron28

I know the boat is a 2000 the ecm says 03 but the...

I know the boat is a 2000 the ecm says 03 but the harness says
2000. I bypassed the lanyard. Usually when it shuts off it will
restart immediately. I did have it not start on the trailer and after...

Forum: General Q & A

08-20-2011, 11:37 PM

Replies: 24

496 mag shuts off going down the lake

Views: 7,860

Posted By heavyiron28

Is there a way to test it? ohms ect? Would this...

Is there a way to test it? ohms ect? Would this make the gauges go flat also?

I sure will look at it. thanks for the help!!!

Forum: General Q & A

08-20-2011, 02:42 PM

Replies: 21

backfiring through the carburetor???

Views: 4,403

Posted By heavyiron28

What ignition are you using? Was the motor just...

What ignition are you using? Was the motor just installed or proven and the problem started suddenly? It sounds like a timing advance
problem to me. If you had low compression you would see it on ...

Forum: General Q & A

08-20-2011, 02:32 PM

Replies: 24

496 mag shuts off going down the lake

Views: 7,860

Posted By heavyiron28

Ya it could be but it is clean and no corrosion...

Ya it could be but it is clean and no corrosion and you can almost pull it completely off before it would kill the motor. I had a buddy with the same set up have the same problem. His fix was to...

Forum: General Q & A

08-19-2011, 12:23 PM

Replies: 24

496 mag shuts off going down the lake

Views: 7,860

Posted By heavyiron28

496 Mag

I would agree that it could be except the gauge issue when it
shuts off they go flat and it does not lead into any pre signs of fuel shudder just running one second and off the next like you turned...

Forum: General Q & A

08-19-2011, 12:05 PM

Replies: 24

496 mag shuts off going down the lake

Views: 7,860

Posted By heavyiron28

496 mag shuts off going down the lake

I have a 496 Mag 2000 year, from time to time it will just quit while
going down the lake. The gauges go flat and nothing. Turn the key off and restart it runs fine. I have been over everything,...

Showing results 1 to 8 of 8