Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: NTIMID8R
Showing results 1 to 11 of 11
Search took 0.00 seconds.
Forum: General Q & A
07-08-2014, 07:09 PM
Replies: 7
Views: 2,409
Posted By NTIMID8R

Thanks for the replies...that's good to know...

Thanks for the replies...that's good to know about those codes.

I have another sensor I can try this weekend.

Question regarding the scan tool, can they measure sea water pressure? I looked...
Forum: General Q & A
07-06-2014, 06:44 PM
Replies: 7
Views: 2,409
Posted By NTIMID8R

Got the scan tool this weekend. After idling the...

Got the scan tool this weekend. After idling the engine for a little bit, here is what I saw on the scan tool.
Engine temp was 145 degrees F.
Oil Pressure at 755 rpm was 52 psi.
If I increase...
Forum: General Q & A
07-01-2014, 08:03 PM
Replies: 7
Views: 2,409
Posted By NTIMID8R

Yes, gauge goes to zero when shut off. I should...

Yes, gauge goes to zero when shut off. I should have access to a scan tool late next week.
Forum: General Q & A
06-29-2014, 08:42 PM
Replies: 7
Views: 2,409
Posted By NTIMID8R

525 EFI Oil Pressure to High at Idle

I have a 2004 525 EFI and just this past weekend noticed my oil pressure gauge reading funny. Normally it is around 35-40 at idle and 60 when over 3000 rpm under normal operating temps...now it is...
Forum: General Q & A
03-27-2013, 10:59 PM
Replies: 0
Views: 1,388
Posted By NTIMID8R

Mercury 525 EFI Adapter Harness

Getting ready to install a 2004 525 EFI with a 10 pin harness into a 2007 boat where a 6.2 MPI non DTS was equipped with a 14 pin harness.
Since I only have analog gauges, can I just buy the...
Forum: Wanted
02-11-2013, 06:28 PM
Replies: 7
Views: 881
Posted By NTIMID8R

"Mercury Racing" on the valve covers are...

"Mercury Racing" on the valve covers are engraved.
Forum: Swap Shop
02-08-2013, 07:04 PM
Replies: 7
Views: 1,432
Posted By NTIMID8R

Dustin, I have attached a couple pictures you...

Dustin, I have attached a couple pictures you took of the motor.

http://i19.photobucket.com/albums/b159/BAN_ONE/securedownload1_zps35634660.jpg
...
Forum: Swap Shop
02-01-2013, 07:00 PM
Replies: 1
Views: 523
Posted By NTIMID8R

PM sent

PM sent
Forum: Wanted
12-29-2012, 01:07 PM
Replies: 2
Views: 492
Posted By NTIMID8R

PM sent ..thanks

PM sent ..thanks
Forum: Wanted
12-26-2012, 01:33 PM
Replies: 2
Views: 492
Posted By NTIMID8R

525 EFI Power Steering Parts

Looking for power steering setup for 525 efi. I already have a new pump..and I will probably go aftermarket on the reservior. So basically blue pulley, pump pulley hub, PS cooler & bracket, lines,...
Forum: Swap Shop
09-07-2012, 02:52 PM
Replies: 3
Views: 660
Posted By NTIMID8R

PM sent

PM sent
Showing results 1 to 11 of 11


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.