Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: nothing_fancy
Showing results 1 to 15 of 15
Search took 0.00 seconds.
Forum: Do It Yourself, Boating on a Budget
09-29-2013, 04:24 PM
Replies: 23
Views: 3,658
Posted By nothing_fancy

Finely got a chance to do some more testing of...

Finely got a chance to do some more testing of the pump today I disconnected the weep tube for the heck of it no improvement. I installed a tee and some hose between the pump and carb with another...
Forum: Do It Yourself, Boating on a Budget
09-27-2013, 07:18 PM
Replies: 23
Views: 3,658
Posted By nothing_fancy

Took out the carb filters that I installed when...

Took out the carb filters that I installed when it was new a couple of months ago they were clean any how. Onto the pumps one was the original that came withe the boat when I bought it and then...
Forum: Do It Yourself, Boating on a Budget
09-23-2013, 09:02 PM
Replies: 23
Views: 3,658
Posted By nothing_fancy

I would try another but I'm having trouble...

I would try another but I'm having trouble believing that both pumps I've got are bad. I'm thinking of going electric but if I don't have to ill save my money for some stainless risers. If it is the...
Forum: Do It Yourself, Boating on a Budget
09-23-2013, 06:03 PM
Replies: 23
Views: 3,658
Posted By nothing_fancy

The weep tube is on the nipple that dumps into...

The weep tube is on the nipple that dumps into the top of the secondary side of the carb where it should. So it's not receiving manifold vacuum
Forum: Do It Yourself, Boating on a Budget
09-23-2013, 05:18 PM
Replies: 23
Views: 3,658
Posted By nothing_fancy

Pulled the pump push rod and compared it to a305...

Pulled the pump push rod and compared it to a305 and it's the same 5.75in rod and checked on summit racing that's what it should be. So is my new fuel pump junk or to small???
Forum: Do It Yourself, Boating on a Budget
09-23-2013, 11:25 AM
Replies: 23
Views: 3,658
Posted By nothing_fancy

I was thinking about switching to a Holley red...

I was thinking about switching to a Holley red electric pump 67gph at 5 psi
Forum: Do It Yourself, Boating on a Budget
09-23-2013, 11:21 AM
Replies: 23
Views: 3,658
Posted By nothing_fancy

It's all3/8 line most connections are tape less I...

It's all3/8 line most connections are tape less I use a paste thread sealant. The pump push rod appears to be all there nothing hiding in the hole and I'm assuming that the cam loab is fine it's a...
Forum: Do It Yourself, Boating on a Budget
09-23-2013, 09:49 AM
Replies: 23
Views: 3,658
Posted By nothing_fancy

It's mechanical

It's mechanical
Forum: Do It Yourself, Boating on a Budget
09-23-2013, 08:41 AM
Replies: 23
Views: 3,658
Posted By nothing_fancy

And all pressure readings are being taken at the...

And all pressure readings are being taken at the carb inlet with a new auto meter gauge. Is it possible that my set up needs a larger than stock fuel pump? Holley says to have 7psi at idle and a min...
Forum: Do It Yourself, Boating on a Budget
09-23-2013, 08:38 AM
Replies: 23
Views: 3,658
Posted By nothing_fancy

I should have mentioned that I tried running off...

I should have mentioned that I tried running off a bucket of fuel so that rules out the tank vent and when I did that I used a new short section of line. The line from the tank was replaced the end...
Forum: Do It Yourself, Boating on a Budget
09-22-2013, 07:44 PM
Replies: 23
Views: 3,658
Posted By nothing_fancy

Fuel problem on SBC

I've bin chasing fuel issues on a 260 merc for most of the summer. the problem I have right now is I can only get 3 pounds of fuel pressure threw the the rpms. I've changed the fuel pump with a new...
Forum: Scarab
03-15-2013, 04:02 PM
Replies: 3
Views: 648
Posted By nothing_fancy

It's an I/O thinking of repowering just...

It's an I/O thinking of repowering just wondering how big I can go..... Or at least how big wellcraft thinks I should go
Forum: Fiberglass and Paint
03-08-2013, 11:34 AM
Replies: 6
Views: 4,835
Posted By nothing_fancy

Yea it's some tough stuff used on a drill rig a...

Yea it's some tough stuff used on a drill rig a couple of years ago still has a good shine still and it's bin exposed to some nasty stuff, rig has Olny worked on hazmat sights. To get to the point I...
Forum: Fiberglass and Paint
03-07-2013, 06:37 PM
Replies: 6
Views: 4,835
Posted By nothing_fancy

Ppg delfleet evolution

Has anyone used this paint before its a polyurethane single stage. I was just wondering how it might compare to some of the other paints out there. And I am aware of the dangers of using polys, I...
Forum: Scarab
03-07-2013, 06:17 PM
Replies: 3
Views: 648
Posted By nothing_fancy

Scarab 1 data tag

Dose anyone have the info off the tag on the port side of the cockpit, the one with the hp limit occupancy and such. Should mention this for an 86 scarab 1
Showing results 1 to 15 of 15


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.