Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: chris82007
Showing results 1 to 12 of 12
Search took 0.01 seconds.
Forum: Drives and Lower Units
03-12-2024, 02:09 PM
Replies: 10
Views: 1,525
Posted By chris82007

Thank you everyone, After speaking with SEI,...

Thank you everyone,

After speaking with SEI, I'll be going with a 1.65 drive and more prop.

Also, check out post#7 by BBlades here, ...
Forum: Drives and Lower Units
03-08-2024, 08:50 AM
Replies: 10
Views: 1,525
Posted By chris82007

Question about running more gear

Hi Everyone.

I need a new B1 outdrive.
Current B1 is a 1.5 ratio and I run a Mirage Plus 21 to 5000 rpm @55mph

I sometimes like to run my Mirage Plus 23 but my hole shot sucks and upper rpm is...
Forum: Drives and Lower Units
03-15-2016, 01:17 PM
Replies: 15
Views: 2,664
Posted By chris82007

Thanks for the suggestions everyone, went with a...

Thanks for the suggestions everyone, went with a new lower from SEI and a Simrek shower. Only thing I had to do was tap and plug the oil passage that doesn't exist on my upper.

Just about ready...
Forum: Drives and Lower Units
01-11-2016, 10:40 AM
Replies: 15
Views: 2,664
Posted By chris82007

Drive was down, it just now got down to below...

Drive was down, it just now got down to below freezing here in TN.
Forum: Drives and Lower Units
01-10-2016, 05:13 PM
Replies: 15
Views: 2,664
Posted By chris82007

I boat in middle TN lakes. I don't know that...

I boat in middle TN lakes.

I don't know that I need the low pick. What is the purpose of having the additional pickup?

Edit: found my answer:...
Forum: Drives and Lower Units
01-10-2016, 04:34 PM
Replies: 15
Views: 2,664
Posted By chris82007

Thanks everyone, looking at a lower from SEI. ...

Thanks everyone, looking at a lower from SEI.

Looks like I have two options, 1 with low water pickup and without. Current drive does not have low water pickup.
Can I use the one with the low...
Forum: Drives and Lower Units
01-10-2016, 11:19 AM
Replies: 15
Views: 2,664
Posted By chris82007

Found a crack on the lower, a few questions

So, I found this yesterday on my 89 Bravo1

On my last outing before winter layup I bumped something during launch, lake was low. I inspecting but apparently didn't see this.

How bad is this?...
Forum: Do It Yourself, Boating on a Budget
08-11-2015, 05:01 PM
Replies: 8
Views: 1,283
Posted By chris82007

Ok, I can feel the slot and the nut in...

Ok,

I can feel the slot and the nut in there. I tried tightening again but the bolt is just spinning so it must be stripped. So if it won't tighten it probably will not loosen...

thoughts?
Forum: Do It Yourself, Boating on a Budget
08-11-2015, 03:14 PM
Replies: 8
Views: 1,283
Posted By chris82007

Nope, Don't feel anything but the end of the...

Nope, Don't feel anything but the end of the bolt. I'll see if I can feel the nut on the other side.
Forum: Do It Yourself, Boating on a Budget
08-11-2015, 02:51 PM
Replies: 8
Views: 1,283
Posted By chris82007

Ah, thus the reason I cannot feel it... Any idea...

Ah, thus the reason I cannot feel it... Any idea why it will not tighten? maybe there is no nut...
Forum: Do It Yourself, Boating on a Budget
08-11-2015, 02:35 PM
Replies: 8
Views: 1,283
Posted By chris82007

Rear port engine mount bolt loose

89 454 Bravo1

I noticed the other day that the port side rear mount bolt was loose, I tried to tighten it but it just spins. Does the nut get pulled inside the mount, I don't feel it on the...
Forum: General Q & A
02-05-2015, 01:38 PM
Replies: 63
Views: 50,086
Posted By chris82007

What about...

What about http://www.summitracing.com/parts/cca-11-232-3 ?
Showing results 1 to 12 of 12


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.