Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: ThGdThBdThUgly
Showing results 1 to 14 of 14
Search took 0.00 seconds.
Forum: General Q & A
07-08-2016, 11:53 PM
Replies: 20
Views: 3,816
Posted By ThGdThBdThUgly

If you are running a Mefi 1, I don't believe it...

If you are running a Mefi 1, I don't believe it is going to be easy to tune with what is sent in the kit by procharger.
Hopefully you have a Mefi 4 and a 2 bar map sensor. I am running a A1000 and...
Forum: General Q & A
07-08-2016, 11:01 PM
Replies: 43
Views: 5,297
Posted By ThGdThBdThUgly

This is almost the same thing that happened to me...

This is almost the same thing that happened to me a couple weeks ago.
Head gaskets were gone. No water in oil on mine either.
Compression test and leak test will tell you for sure.
Forum: General Q & A
07-08-2016, 10:55 PM
Replies: 18
Views: 7,639
Posted By ThGdThBdThUgly

Was this your original block and heads? If so...

Was this your original block and heads? If so what was the cause for a rebuild if any?
Forum: General Q & A
07-08-2016, 09:14 PM
Replies: 20
Views: 2,645
Posted By ThGdThBdThUgly

Yeah, Marine Block (MPI Mercruiser). I got...

Yeah, Marine Block (MPI Mercruiser).
I got lucky finding one within 500 miles. LoL
Forum: General Q & A
07-08-2016, 08:37 PM
Replies: 20
Views: 2,645
Posted By ThGdThBdThUgly

So pulled both heads off and the right side was...

So pulled both heads off and the right side was blown between every cylinder. The left was starting to go between every cylinder. I am sure the previous owner knew it had got hot at some point...
Forum: General Q & A
07-06-2016, 02:23 AM
Replies: 20
Views: 2,645
Posted By ThGdThBdThUgly

Well tonight I did a leak test and confirmed the...

Well tonight I did a leak test and confirmed the problem when air started coming out the adjacent cylinders.
Head gasket was blown between each cylinder. Good thing I ordered Fel-Pro gaskets and...
Forum: General Q & A
07-04-2016, 10:06 PM
Replies: 20
Views: 2,645
Posted By ThGdThBdThUgly

Will do that tomorrow before I tear into anything.

Will do that tomorrow before I tear into anything.
Forum: General Q & A
07-04-2016, 08:58 PM
Replies: 20
Views: 2,645
Posted By ThGdThBdThUgly

I would be stoked if it is a head gasket. What...

I would be stoked if it is a head gasket. What do you think the chances are? I will start pulling the head off in the boat tomorrow night. Probably should do both huh?
Forum: General Q & A
07-04-2016, 08:52 PM
Replies: 20
Views: 2,645
Posted By ThGdThBdThUgly

I guess I could pickup a used harness and re-ring...

I guess I could pickup a used harness and re-ring it. The thing has ran fine all season and it only has 185 hours on it. It is weird that it is that side only with the lower compression. I watched...
Forum: General Q & A
07-04-2016, 07:46 PM
Replies: 20
Views: 2,645
Posted By ThGdThBdThUgly

So I went out and checked compression today. ...

So I went out and checked compression today.
Cylinders 1,3,5,7 = 139-145 psi
Cylinders 2, 4, 6, 8 = 45 psi
Forum: General Q & A
07-04-2016, 01:13 PM
Replies: 20
Views: 2,645
Posted By ThGdThBdThUgly

Thanks, I do have the scan tool and it has no...

Thanks, I do have the scan tool and it has no codes.
Do you know what voltage the Mefi prefers? When the engine is not running the scan tool shows 12.4 volts. When engine is running it is...
Forum: General Q & A
07-03-2016, 10:27 PM
Replies: 20
Views: 2,645
Posted By ThGdThBdThUgly

Looking for help on my 502

So last weekend the engine was idling high and surging, jumped online found that I should probably check IAC. Went ahead and installed a new one along with a TPS and Map sensor since I was there. ...
Forum: Swap Shop
05-16-2016, 12:08 AM
Replies: 44
Views: 7,256
Posted By ThGdThBdThUgly

PM Sent

PM Sent
Forum: Wanted
04-18-2016, 12:00 AM
Replies: 0
Views: 281
Posted By ThGdThBdThUgly

WTB: Supercharger for 502 Mag

Looking for a good used supercharger to bolt on my stock 502 mag.
Let me know if you have a take off.

Thanks,
Showing results 1 to 14 of 14


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.