Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: ragtp66
Showing results 1 to 14 of 14
Search took 0.01 seconds.
Forum: Sea Ray
08-08-2013, 09:13 AM
Replies: 5
Views: 1,772
Posted By ragtp66

This might or might not pan out but try these...

This might or might not pan out but try these guyshttp://www.melrosecorvette.com/contact-us/ they rebuild the glass tops on corvettes, I had one on my 85 and its some type of plastic its not glass...
Forum: Sea Ray
04-05-2012, 12:20 AM
Replies: 1
Views: 1,153
Posted By ragtp66

Am/fm radio antennae

I have been doing a little spring repairs on my 87 P-22 and was cleaning up some sloppy wiring from the previous owners stereo install and while tracing the power and grounds I was curious and...
06-11-2010, 12:02 AM
Replies: 2
Views: 4,355
Posted By ragtp66

Help adjusting Trim limit switch on Alpha One

Can someone please tell me what the dimension (center of trim lift mounting bolts) is supposed to be when adjusting the trim limit sensor? I thought it was supposed to be 22" = or - 1/4 on center....
Forum: General Q & A
04-18-2010, 11:41 PM
Replies: 4
Views: 677
Posted By ragtp66

Wires are installed 100% correct. It is not...

Wires are installed 100% correct. It is not misfiring or backfiring just running very rich. I thought about checking the fuel pressure but I don't have a gauge for carbureted I do have a gauge for...
Forum: General Q & A
04-18-2010, 10:05 PM
Replies: 4
Views: 677
Posted By ragtp66

Help with running rich 7.4L 300 hp

I have 87 Pachanga with 7.4L Alpha combo. All stock. At the end of last season my fuel pump failed. I replaced that with a genuine Merc pump. When I restarted the boat it was running rich so I...
04-18-2010, 09:27 PM
Replies: 51
Views: 23,812
Posted By ragtp66

Try picking one of these up...

Try picking one of these up http://www.summitracing.com/parts/FEL-16202 from any local auto parts store they work great to repair the groove on the balancer snout if you don't fix that problem the...
Forum: Sea Ray
04-04-2010, 08:35 PM
Replies: 83
Views: 9,335
Posted By ragtp66

I would be in coming from Illinois

I would be in coming from Illinois
Forum: General Q & A
10-01-2009, 02:18 AM
Replies: 16
Views: 1,688
Posted By ragtp66

Sorry its been a while since I have been able to...

Sorry its been a while since I have been able to get back on.
Carb is completely stock rochester quadrajet. I will look again at the underside of the arm and see if I can see any wear marks from...
Forum: General Q & A
09-23-2009, 11:34 PM
Replies: 16
Views: 1,688
Posted By ragtp66

Firing order is correct. I have not yet checked...

Firing order is correct. I have not yet checked fuel pressure I have a fuel pressure gauge but I have to figure out how to rig something up to connect it as the one I have just has the adapter for a...
Forum: General Q & A
09-22-2009, 12:01 AM
Replies: 16
Views: 1,688
Posted By ragtp66

Angry Updating post. Finally was able to get the new...

Updating post. Finally was able to get the new fuel pump put on and then the fun begins. So I tried to get the oil plug out and even with a 12" breaker bar I cannot get it to budge KING KONG must...
Forum: General Q & A
08-20-2009, 11:38 PM
Replies: 16
Views: 1,688
Posted By ragtp66

Yes it is a gen IV block all stock in an 87 Sea...

Yes it is a gen IV block all stock in an 87 Sea Ray Pachanga with about 325 hours on it. I was not planning on rebuilding or pulling the motor if I did not have to. I could drop the pan without...
Forum: General Q & A
08-20-2009, 08:54 PM
Replies: 16
Views: 1,688
Posted By ragtp66

help with fuel pump 454/330hp

I am working with a 330hp/454 alpha one combo with a mechanical fuel pump. I went to remove the pump and the spring that normally would be found under the actuator arm was gone.It was nowhere in the...
Forum: General Q & A
04-23-2007, 01:02 PM
Replies: 13
Views: 4,397
Posted By ragtp66

I thought I was the only one with this issue. I...

I thought I was the only one with this issue. I have a 87 SR Pachanga 22 with a 454Magnum/330hp. Exhaust always has steam coming from it. I bought the boat about a year ago and unfortunately I didn't...
02-27-2006, 01:36 AM
Replies: 1
Views: 1,607
Posted By ragtp66

1991 Wellcraft Excalibur

I know that a little boat like this 23' probably is of no interest to most of you all on here but I do have a couple of questions.. Compared to a ScarabI of the same vintage or a Sea Ray Pachanga 22...
Showing results 1 to 14 of 14


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.