Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: jodane
Showing results 1 to 16 of 16
Search took 0.01 seconds.
06-20-2011, 10:44 PM
Replies: 10
Views: 1,829
Posted By jodane

Ok, so hard is it to pull the drive? If I'm going...

Ok, so hard is it to pull the drive? If I'm going to pull the drive should I go ahead and order a seal kit, with new bellows, seals and gaskets? And if I order a kit is there a special one I should...
06-18-2011, 10:52 PM
Replies: 10
Views: 1,829
Posted By jodane

Drained some fluid from the drive today and it...

Drained some fluid from the drive today and it looked fine. A little dark but still green. I didn't see any leak trails from the bottle or the hose. But where the hose into the tramsom, it looks a...
05-11-2011, 05:01 PM
Replies: 10
Views: 1,829
Posted By jodane

It's an Bravo XZ. Was installed the winter before...

It's an Bravo XZ. Was installed the winter before last season when we put in a new motor. I'll take it in to have the bellows checked. I can see where the line from bottle to the transom might be it,...
05-11-2011, 12:34 AM
Replies: 10
Views: 1,829
Posted By jodane

Drive fluid

Any idea why the fluid for my drive would be gone. Ran boat all last season with no problems, then over winter went to run it in the driveway and noticed bottle for drive was empty. Had some oil in...
Forum: General Q & A
01-31-2011, 06:56 PM
Replies: 1
Views: 850
Posted By jodane

audio warning buzzer

I have the electrical system from my old,"01 7.4l MPI on the new 540. Everything has been working fine but, last season the warning buzzer became intermitent and now no longer sounds its 2 beeps at...
05-24-2009, 09:59 AM
Replies: 3
Views: 984
Posted By jodane

thanks, I didn't think it would be an issue but,...

thanks, I didn't think it would be an issue but, wanted some opinions.
05-23-2009, 08:56 PM
Replies: 3
Views: 984
Posted By jodane

Question Which hydraulic steering fluid

I'm in the process of installing an Imco full hydraulic system and wonder about the fluids. Imco told me the best fluid would be Valvoline synthetic PS. Well, they no longer make it. I run Mobil 1...
04-10-2009, 05:44 PM
Replies: 15
Views: 1,484
Posted By jodane

Thanks, Dick. That's what I told them, still...

Thanks, Dick. That's what I told them, still waiting to see if what they said they had matches.
04-08-2009, 11:43 PM
Replies: 15
Views: 1,484
Posted By jodane

So Dick, was that the wrong number for the kit?...

So Dick, was that the wrong number for the kit? I'm trying to set things up with the shop that is going to do the install and want to make sure I'm giving them the right info. They say they have...
04-07-2009, 11:04 PM
Replies: 8
Views: 1,053
Posted By jodane

Thanks for the info. I'm having the XZ installed...

Thanks for the info. I'm having the XZ installed this week then when I get it back I'll try to get the shift right.
04-07-2009, 12:22 AM
Replies: 8
Views: 1,053
Posted By jodane

Do I move the black piece closer to the cable...

Do I move the black piece closer to the cable housing to tighten or turn it closer to the end of the cable to tighten? I've found the cables I just wasn't sure which way would make it engage sooner....
04-06-2009, 10:17 PM
Replies: 8
Views: 1,053
Posted By jodane

Bravo 1, soon to be bravo XZ.

Bravo 1, soon to be bravo XZ.
04-06-2009, 07:02 PM
Replies: 8
Views: 1,053
Posted By jodane

Shift-throttle adjusting

Can someone help me with instructions on how to adjust my oudrive cables? Std. mercury side mount single control. After our new motor was installed my Forward/Rev has been off, late to engage. I'm...
03-29-2009, 12:49 PM
Replies: 15
Views: 1,484
Posted By jodane

Thanks Dick, I will be getting to it in a few...

Thanks Dick, I will be getting to it in a few days.
Jon
03-28-2009, 10:38 PM
Replies: 15
Views: 1,484
Posted By jodane

Ok, so gimbal bearing kit and ram spacers...

Ok, so gimbal bearing kit and ram spacers correct? Where do I look on the drive to make sure I get the correct kit? Do I have to have the old one out to find this #? Is there any real disadvantage to...
03-28-2009, 04:37 PM
Replies: 15
Views: 1,484
Posted By jodane

Newer Xz drive with old B1 transom

I have just purchased an XZ drive and wonder if my '01 Bravo 1 assembly is going to work with it or am I going to have the same issues people with XR have? If I do need new is it worth it to use an...
Showing results 1 to 16 of 16


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.