Offshoreonly.com - Search Results

Search: Posts Made By: Martin B

Showing results 1 to 4 of 4
Search took 0.00 seconds.

Forum: Detailing, Painting, & Fiberglass

04-21-2010, 09:23 PM

Replies: 4

Larson boats question.

Views: 1,382

Posted By Martin B

It's mainly questions about the initial...

It's mainly questions about the initial performance of the new Delta Conic hulls and the various improvements made during the first years of productions. Usually when a new hull is put into...

Forum: Detailing, Painting, & Fiberglass

09-08-2008, 08:03 AM

Replies: 35

Blueprinting the bottom

Views: 14,504

Posted By Martin B

I'm very interested in what you might have...

I'm very interested in what you might have gained. I have not found much at all on the smaller boats unless they are running 80+ mph. 1 or 2 mph is about it unless there was an obvious flaw. 30'...

Forum: Detailing, Painting, & Fiberglass

09-08-2008, 07:52 AM

Replies: 7

Need to remove paint for vinyl graphics, what's the best method

Views: 2,227

Posted By Martin B

Couldn't they just apply a layer of white vinyl...

Couldn't they just apply a layer of white vinyl just over the blue and then put the blue vinyl over that? It's going to be a fair amount of work to sand all that paint off and then finish it all...

Forum: Swap Shop

09-04-2008, 07:08 PM

Replies: 0

20P Enertia Prop 3 blade RH

Views: 1,176

Posted By Martin B

20P Enertia Prop 3 blade RH

This prop is pretty much brand new. I switched from a Mirage 19 plus and I gained 2 mph top end but it did not do what I needed for tubing. I have the Mercury box that it came in and the XR hub. It...

Showing results 1 to 4 of 4