Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: vdriven
Showing results 1 to 21 of 21
Search took 0.00 seconds.
Forum: General Q & A
12-23-2021, 10:47 PM
Replies: 6
Views: 1,140
Posted By vdriven

1986 JOHNSON GT 3.6 outboard.

I just purchased a 1986 BAHA sport 220 boat with a 1986 Johnson GT 3.8 V8 outboard. What are the good and weak points of these motors, also what causes them to break the prop shafts ?
12-23-2021, 10:40 PM
Replies: 2
Views: 886
Posted By vdriven

OMC v8 outboards, broken prop shafts

What causes these engines to break the prop shafts ?
Forum: Formula
08-25-2019, 05:08 PM
Replies: 2
Views: 590
Posted By vdriven

Question F272 SR1 Breaker Panel Access

I have a 1989 F 272 SR1 That I need to access the 12 volt and 120 volt breaker panel, it is located in the cuddy locker next to the sink and wet bar. The locker is about 3" high, 12" wide and about...
Forum: General Q & A
01-07-2014, 06:58 PM
Replies: 2
Views: 1,021
Posted By vdriven

Top mount starter bell housing for bravo 1

Anyone know if they make a top mount starter bell housing for a Bravo 1 setup ? If so does it use the same starter as the TRS does ??
01-07-2014, 06:43 PM
Replies: 6
Views: 670
Posted By vdriven

Bravo 1 Top Mount Starter

Does anyone know if they make a top mount starter bell housing for a Bravo 1 setup ?? If so does it use the same starter as the TRS units did ?
Forum: Scarab
06-21-2011, 12:22 PM
Replies: 11
Views: 1,500
Posted By vdriven

Hi: I have a like new set of Mirage plus 23 Pitch...

Hi: I have a like new set of Mirage plus 23 Pitch props for sale, Contact me. [email protected]
Forum: General Q & A
05-26-2011, 06:34 PM
Replies: 23
Views: 18,122
Posted By vdriven

If you are running this with a Mercruiser alpha...

If you are running this with a Mercruiser alpha drive, it would be a lot less screwing around if you remodel your outdrive to turn L.H. ?? Or even run them both R.H. if you have power steering on it...
Forum: General Q & A
05-23-2011, 02:22 PM
Replies: 3
Views: 591
Posted By vdriven

I am looking for some more feedback and...

I am looking for some more feedback and suggestions to my ignition problem .
Forum: General Q & A
05-22-2011, 11:20 PM
Replies: 3
Views: 591
Posted By vdriven

The wiring on that engine is exactly the same as...

The wiring on that engine is exactly the same as it was with the old motors and this distributor worked for three years with no problems. As I stated the only thing in the electrical system that isnt...
Forum: General Q & A
05-22-2011, 07:39 PM
Replies: 3
Views: 591
Posted By vdriven

Ignition Module Problem

HERE IS A QUESTION FOR YOU ELECTRICAL GURU'S i HAVE BEEN RUNNING A SET OF HEI DISTRIBUTORS IN MY SCARAB,WITH BBCs WITH NO PROBLEMS. I PUT A SET OF NEW ENGINES IN THE BOAT LAST YEAR AND ALSO REPLACED...
Forum: General Q & A
05-14-2011, 11:13 PM
Replies: 10
Views: 2,716
Posted By vdriven

Hey guys I am looking for some more input on this...

Hey guys I am looking for some more input on this problem, any suggestions appreciated.
Forum: General Q & A
05-11-2011, 01:06 AM
Replies: 7
Views: 811
Posted By vdriven

I think Poker Runs is still published !! That is...

I think Poker Runs is still published !! That is affiliated with offshore only that does this seb sight !!
Forum: General Q & A
05-11-2011, 12:40 AM
Replies: 25
Views: 3,968
Posted By vdriven

If you are on a lake where you have waves and...

If you are on a lake where you have waves and wind the last thing you want is a floating lift, I live in W Centeral Mn. and on a lake, I have a 30' Scarab and am using a Newman 9000 lb verticle lift...
Forum: General Q & A
05-10-2011, 11:24 PM
Replies: 6
Views: 1,173
Posted By vdriven

Real simple solution, run a switch for each...

Real simple solution, run a switch for each actuator, problem solved, mine has always had a switch for each side.
Good Luck.
Forum: General Q & A
05-10-2011, 01:20 PM
Replies: 10
Views: 2,716
Posted By vdriven

Hi again: Did you pressure check the exhaust...

Hi again: Did you pressure check the exhaust system, or the engine with the exhaust taken off ?? Or was your exhaust elbow leaking and running down into the exhaust ports in the head ?? Thanks again.
Forum: General Q & A
05-10-2011, 01:15 PM
Replies: 10
Views: 2,716
Posted By vdriven

When you say you were leaking water from your...

When you say you were leaking water from your heads, exhaust ports into the engine, what do you mean ?? were your heads cracked ?? or did you have a gasket leaking, ?? Elbow cracked ?? What exhaust...
Forum: General Q & A
05-07-2011, 10:36 PM
Replies: 10
Views: 2,716
Posted By vdriven

Engines are both running 160 degrees. Keep in...

Engines are both running 160 degrees. Keep in mind that I have run these motors for three years and this has never happened before. Thanks for your input.
Forum: General Q & A
05-07-2011, 09:48 PM
Replies: 10
Views: 2,716
Posted By vdriven

Moisture In Oil

I have an older 30' Scarab that I rebuilt and I built a pair of 468 CI BBC. The engines are making close to 500 HP. They have been run for 3 years on a small MN. lake, and have about 25 hours of...
05-07-2011, 09:21 PM
Replies: 17
Views: 3,902
Posted By vdriven

Check your oil coolers, with about 40 to 50 lbs...

Check your oil coolers, with about 40 to 50 lbs of air pressure, YOU WILL FIND A LEEK, GOOD LUCK
04-14-2011, 06:38 PM
Replies: 14
Views: 5,926
Posted By vdriven

18' Mandella long deck. Scarab 300

Buy a how to Big Block Chevy Manuel, and do it step by step, Picture by picture, all the torque specs. and other info. that you will need should be in there. Good Luck.
Showing results 1 to 21 of 21


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.