Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Team Archer
Showing results 1 to 3 of 3
Search took 0.00 seconds.
Forum: Scarab
04-03-2019, 02:27 PM
Replies: 6
Views: 833
Posted By Team Archer

Shaggy I would for sure raise the X on your boat...

Shaggy I would for sure raise the X on your boat with a -2 inch drive lower. Wellcraft was very conservative with drive heights Regards Dan
Forum: Scarab
03-12-2019, 08:59 PM
Replies: 6
Views: 833
Posted By Team Archer

it makes it hard to measure with out the drives...

it makes it hard to measure with out the drives but if you are pulling the transom assy's off any ways you can measure off the bolt holes. Its a lot to type out how to do it but feel free to give me...
Forum: Scarab
03-11-2019, 01:14 PM
Replies: 6
Views: 833
Posted By Team Archer

If I were doing this I would raise the drives at...

If I were doing this I would raise the drives at least 2 inches I would need to know the original X dimension to give you an exact number Regards Dan
Showing results 1 to 3 of 3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.