Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Esox4130
Showing results 1 to 5 of 5
Search took 0.01 seconds.
Forum: Skater
05-20-2017, 07:18 PM
Replies: 1,124
Views: 289,980
Posted By Esox4130

Did you try them out

Did you try them out
Forum: Skater
05-10-2017, 08:16 AM
Replies: 1,124
Views: 289,980
Posted By Esox4130

It's there a valve between motors to. If one...

It's there a valve between motors to. If one motor isn't running isn't all water going to dump out other while idling etc.
Forum: Skater
05-09-2017, 07:24 PM
Replies: 1,124
Views: 289,980
Posted By Esox4130

It's to feed the other water if it loses pressure...

It's to feed the other water if it loses pressure when turning etc. when mine were cut in it pinned the water pressure gauges same with my buddy's 24. If your worried about getting into the core take...
Forum: Skater
05-01-2017, 08:25 PM
Replies: 1,124
Views: 289,980
Posted By Esox4130

Look same as my 21 with twins. After they were...

Look same as my 21 with twins. After they were cut in it pegged the water pressure. In the 21 there is no core there it's just about 3/8-1/2 inch thick fiberglass with no core for the last foot. I...
Forum: Skater
04-29-2017, 08:53 AM
Replies: 1,124
Views: 289,980
Posted By Esox4130

Anyone have the water ramp diagram where to cut...

Anyone have the water ramp diagram where to cut in for the 24 with etecs. Cannot find the one I had I was going to send him.
Showing results 1 to 5 of 5


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.