Offshoreonly.com - Search Results

Search: Posts Made By: Liberator21

Showing results 1 to 4 of 4
Search took 0.00 seconds.

Forum: General Q & A

01-15-2004, 08:13 PM

Replies: 10

vortec heads for pre-vortech engine??

Views: 8,616

Posted By Liberator21

I looked at it again. It's aluminum. I can't find...

I looked at it again. It's aluminum. I can't find the cast iron high rise anymore. It was there about 8 months ago last time I was on the site. I did find this one (14097499). It's not a high rise,...

Forum: General Q & A

01-15-2004, 12:23 PM

Replies: 10

vortec heads for pre-vortech engine??

Views: 8,616

Posted By Liberator21

Here it is. I thought it was dual pattern though....

Here it is. I thought it was dual pattern though. I'll have to double check the part numbers I have at home.

This dual-plane was designed for 283-400 ci small-block Chevrolet engines using the new...

Forum: General Q & A

01-15-2004, 11:11 AM

Replies: 10

vortec heads for pre-vortech engine??

Views: 8,616

Posted By Liberator21

There is a cast iron intake available for the...

There is a cast iron intake available for the vortec head. It's a high rise manifold based on the Z-28 aluminum manifold. The carb mounting flange is dual pattern. Fits both the Holley and the Q-Jet....

Forum: General Q & A

01-14-2004, 07:42 PM

Replies: 10

vortec heads for pre-vortech engine??

Views: 8,616

Posted By Liberator21

If you're going to go Vortec, remember: In stock...

If you're going to go Vortec, remember: In stock trim they don't have 2.02 valves, and they are limited to the amount of cam you can use before you have to start machining spring seats (Bruce...

Showing results 1 to 4 of 4