Offshoreonly.com - Search Results

Search: Posts Made By: bcarpman

Showing results 1 to 8 of 8
Search took 0.01 seconds.

Forum: General Q & A

08-14-2006, 04:37 PM

Replies: 23

496 Cam Question???

Views: 7,791

Posted By bcarpman

Re: 496 Cam Question???

I'm curious what equation you used? In my GM days, if I had a question like this I'd ask someone in the analysis group to run me some engine simulation numbers during lunch. Can't do that anymore,...

Forum: General Q & A

08-14-2006, 02:36 PM

Replies: 23

496 Cam Question???

Views: 7,791

Posted By bcarpman

Re: 496 Cam Question???

Yep, I'm looking for the EFI model, although your lift specs are higher than I've seen elsewhere. Are those the actual stock cam specs, or just Crane's sort-of-stock cam for that motor?

I've been...

Forum: General Q & A

08-14-2006, 12:27 PM

Replies: 23

496 Cam Question???

Views: 7,791

Posted By bcarpman

Re: 496 Cam Question???

Well, although I started out looking for cam suggestions, I ended up with a lot of good cyl head advice.

However, in that time, I've also gotten some good cam advice, and have decided I'm...

Forum: General Q & A

08-11-2006, 03:26 PM

Replies: 23

496 Cam Question???

Views: 7,791

Posted By bcarpman

Re: 496 Cam Question???

Yes, I've worked with Katech before, and I'm sure their data is trustworthy. I haven't talked to anyone there in a long time, and I'm not sure who "HayJay" is. Hopefully he'll chime in. This...

Forum: General Q & A

08-11-2006, 12:50 PM

Replies: 23

496 Cam Question???

Views: 7,791

Posted By bcarpman

Re: 496 Cam Question???

Are you sure those flow numbers aren't for the old L-29? I think there was an L29 years ago that was a real pig. I do know that out of the box, the new L29 head should flow a little better than...

Forum: General Q & A

08-11-2006, 12:32 PM

Replies: 23

496 Cam Question???

Views: 7,791

Posted By bcarpman

Re: 496 Cam Question???

I like to look at engine component selection "holistically". I agree one of the biggest mistakes people make when putting together an engine is selecting any one component that's way over done for...

Forum: General Q & A

08-11-2006, 10:33 AM

Replies: 23

496 Cam Question???

Views: 7,791

Posted By bcarpman

Re: 496 Cam Question???

I don't have the heads yet. I've got a line on a pair of stock heads as well as a pair of slightly reworked heads with stainless valves. I'm holding off on a decision until I decide on a cam.
...

Forum: General Q & A

08-11-2006, 09:17 AM

Replies: 23

496 Cam Question???

Views: 7,791

Posted By bcarpman

496 Cam Question???

Ok, I'm finally crawling out from lurker mode. Thanks to everyone here for all the help so far in all the old threads.

I'm doing my own version of 330 on roids and have probably read through 200...

Showing results 1 to 8 of 8