Offshoreonly.com - Search Results

Search: Posts Made By: psi

Showing results 1 to 4 of 4
Search took 0.00 seconds.

Forum: Eliminator

10-05-2010, 09:11 PM

Replies: 16

25 daytona questions

Views: 11,159

Posted By psi

Most definately didnt wanna take over Kens thread...

Most definately didnt wanna take over Kens thread but give some of my feedback as well....I most definately did measure from the bottom of the sponsons...thats the only place to measure from! My...

Forum: Eliminator

10-05-2010, 12:10 AM

Replies: 16

25 daytona questions

Views: 11,159

Posted By psi

OK, lets see where to start...when I purchased...

OK, lets see where to start...when I purchased the boat from Eliminator it already had the -2in lower on it. When U measured the prop shaft (or front of the nose cone) in level trim it was about...

Forum: Eliminator

10-04-2010, 08:10 PM

Replies: 16

25 daytona questions

Views: 11,159

Posted By psi

Hey Dirty.... Yes... that is the 3in raised...

Hey Dirty.... Yes... that is the 3in raised 12inch set back Ex. box.... Like I explained before not sure ho much we can relate my x dimension set up cause the motor is so drastically different...(1...

Forum: Eliminator

10-03-2010, 05:23 PM

Replies: 16

25 daytona questions

Views: 11,159

Posted By psi

Hey Guys...When I built my 25 Daytona I was also...

Hey Guys...When I built my 25 Daytona I was also back and forth with Eliminator regarding the height of my drive...I also felt it was also mounted to low and it had a -2 shorty lower....the problem...

Showing results 1 to 4 of 4