Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: liberator221
Showing results 1 to 25 of 38
Search took 0.01 seconds.
06-10-2021, 04:25 AM
Replies: 7
Views: 180
Posted By liberator221

Get a noid light and put in injector harness to...

Get a noid light and put in injector harness to check signal.
Typically injectors have constant 12v with key on and ECM controls ground.
Forum: General Q & A
06-09-2021, 08:18 AM
Replies: 11
Views: 447
Posted By liberator221

Installed this same unit over the winter and have...

Installed this same unit over the winter and have the same problem with sometimes staying in warm up cycle. Called Autometer tech line, they told me to connect the brown wire, which is supposed to be...
Forum: General Q & A
06-01-2021, 03:14 PM
Replies: 45
Views: 1,343
Posted By liberator221

Great to hear your boating. I learned something...

Great to hear your boating. I learned something from AllDodge also about running them in a bucket. Had no idea. Thatís why I set around and read this stuff.
Forum: General Q & A
05-25-2021, 01:52 PM
Replies: 45
Views: 1,343
Posted By liberator221

Shoot the temp sending unit and several places...

Shoot the temp sending unit and several places around thermostat housing to see how it compares to gauge reading. Then try to follow the water flow : inlet hose -through coolers-to stat housing- to...
Forum: General Q & A
05-25-2021, 12:37 PM
Replies: 45
Views: 1,343
Posted By liberator221

Before buying any more parts I would get an IR...

Before buying any more parts I would get an IR temp gun and verify gauge readings. They are inexpensive at most any hardware store.
Forum: General Q & A
05-25-2021, 05:01 AM
Replies: 45
Views: 1,343
Posted By liberator221

Did old seawater pump come apart? Debri plugging...

Did old seawater pump come apart? Debri plugging system?(coolers) Engine circulating pump ever been replaced? Bravoitis?
Disconnect hoses and back flush system with water hose. Visually inspect...
04-28-2021, 04:53 PM
Replies: 3
Views: 429
Posted By liberator221

What is the best DIY gelcoat sealant/ceramic...

What is the best DIY gelcoat sealant/ceramic coating to use on a performance boat?check this thread in general boating post. Lot of information/ opinion.
04-27-2021, 08:11 PM
Replies: 5
Views: 564
Posted By liberator221

Just for info: you are not supposed to shift a...

Just for info: you are not supposed to shift a bravo in gear without engine running so donít test it like that.
04-23-2021, 12:27 PM
Replies: 15
Views: 887
Posted By liberator221

I thought any time key was in run position hour...

I thought any time key was in run position hour meter ran whether engine was running or not.
03-31-2021, 08:21 AM
Replies: 23
Views: 2,024
Posted By liberator221

You said "fixed bimini is not an option" ....

You said "fixed bimini is not an option" . Thought maybe a fold away would work. Good luck.
03-31-2021, 08:18 AM
Replies: 387
Views: 28,331
Posted By liberator221

OK one more, how about super gun control Sleepy...

OK one more, how about super gun control Sleepy Joe and Hunters' gun thrown in trash can. Is it no longer a felony to falsify information on a gun app/back ground check? Amazing how that all went...
Forum: Prop Talk
03-22-2021, 01:18 PM
Replies: 8
Views: 547
Posted By liberator221

If you are turning a 22 pitch Bravo one prop 5000...

If you are turning a 22 pitch Bravo one prop 5000 RPM you should be going 58-60MPH not 48. Good luck with your boat. (check that tachometer)
03-10-2021, 07:24 AM
Replies: 12
Views: 1,063
Posted By liberator221

Ditto on JR marine. Give him a call. Very...

Ditto on JR marine. Give him a call. Very helpful. Has stainless steering pin and everything you need to put together and stop the leak.
03-07-2021, 07:38 PM
Replies: 93
Views: 6,346
Posted By liberator221

9250 is boat only? I think F-150ís are great...

9250 is boat only?
I think F-150ís are great but think thatís too much for it. Your getting to the point where the boat owns the truck.
02-26-2021, 06:06 AM
Replies: 387
Views: 28,331
Posted By liberator221

Am I looking at this wrong or does the math not...

Am I looking at this wrong or does the math not make sense
02-20-2021, 02:45 PM
Replies: 387
Views: 28,331
Posted By liberator221

I paid less in taxes= my pay check was bigger ...

I paid less in taxes= my pay check was bigger
cost of living was down= my pay check went farther
retirement/investments had good increase
unemployment was down until covid
scamdemic was not...
02-20-2021, 08:11 AM
Replies: 387
Views: 28,331
Posted By liberator221

Just read an article that said ďthe Biden boom is...

Just read an article that said ďthe Biden boom is just around the corner, economy is going to take off like gangbusters. Great times aheadĒ
where do the libs dig these people up?
Iím thinking the...
Forum: Saber
02-20-2021, 06:15 AM
Replies: 23
Views: 2,267
Posted By liberator221

Projects arenít done but Iím ready for summer.

Projects arenít done but Iím ready for summer.
02-19-2021, 03:09 PM
Replies: 387
Views: 28,331
Posted By liberator221

We have an electric school bus. This technology...

We have an electric school bus. This technology is a LONG way from being dependable and reasonable. Range is only 70-100 miles depending on weather and load. Cost is 4 times that of a diesel powered...
02-17-2021, 01:53 PM
Replies: 387
Views: 28,331
Posted By liberator221

Just the start of bad things that are coming!! ...

Just the start of bad things that are coming!!
$15 minimum wage = drastic increase in cost of product and services.
Forum: General Q & A
12-24-2020, 05:37 AM
Replies: 29
Views: 1,684
Posted By liberator221

I think you can do this with a Bosch 5 pin relay....

I think you can do this with a Bosch 5 pin relay. At rest pin 30 is connected to 87A and when energized pin 30 connects to 87. You can wire the relay to be 12v switched or ground switched depending...
11-29-2020, 09:54 AM
Replies: 151
Views: 9,109
Posted By liberator221

If I understand him, itís not that the engine...

If I understand him, itís not that the engine wonít slow down, like a linkage issue, when he slows it down it dies. I would think way rich or way lean. The fact that it will idle slower cold than hot...
11-12-2020, 01:43 PM
Replies: 9
Views: 882
Posted By liberator221

I,m assuming since it,s mid November you are done...

I,m assuming since it,s mid November you are done till spring. If that is true I would lean real hard toward doing it all. Gimbal bearing,bellows, shift cable boot, lube and inspect u-joints,clean...
11-10-2020, 12:06 PM
Replies: 151
Views: 9,109
Posted By liberator221

I doubt that is it, but take a small wire and...

I doubt that is it, but take a small wire and stick in the rear holes. I think you will find they are not drilled all the way.
11-09-2020, 08:25 PM
Replies: 151
Views: 9,109
Posted By liberator221

With throttle open you are off the idle circuit...

With throttle open you are off the idle circuit any way , but that will get give you a starting point after you find other problem.
Like Alldodge said look to see if fuel dripping out of venturies...
Showing results 1 to 25 of 38
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.