Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: scippy
Showing results 1 to 25 of 288
Search took 0.05 seconds.
11-24-2021, 12:20 AM
Replies: 353
Views: 190,093
Posted By larslindroth

96th 35 built, in May 1982.

96th 35 built, in May 1982.
11-22-2021, 07:55 AM
Replies: 2
Views: 171
Posted By resurrected

Lots of the merc stuff!! Capacities chart is...

Lots of the merc stuff!!
Capacities chart is attached.
11-16-2021, 07:16 AM
Replies: 26
Views: 769
Posted By resurrected

Your video makes short work of that! I have a...

Your video makes short work of that!
I have a service manual for SSM. If there is anything you need just shoot me a message and I can scan it to you.
11-14-2021, 12:13 AM
Replies: 26
Views: 769
Posted By ICDEDPPL

https://www.youtube.com/watch?v=gy3i5p_3uCE ...

https://www.youtube.com/watch?v=gy3i5p_3uCE

I`d replace the bellows if you`re already in there .

Ive pulled drives probably 20 times . That gear oil smell I hate it !!
Forum: Prop Talk
11-12-2021, 12:07 PM
Replies: 1
Views: 181
Posted By Toffen

Phantom 25 w/450R - prop setup

Hi!

I hope you all are well :)

I replaced my 400R with a 450R this summer. With the 400R my boat ran 88 mph at 7,000 rpms with a max5 25 15 dia prop. Sportmaster 1:1,75 gears. Propshaftheight 2...
11-12-2021, 07:17 AM
Replies: 26
Views: 769
Posted By resurrected

Hahaha, it will come out smooth, just keep the...

Hahaha, it will come out smooth, just keep the drive neutral with the helmet. Installation can be challenging, I've slid it in first try and was completely shocked. On other occasions I need to walk...
11-10-2021, 07:31 AM
Replies: 26
Views: 769
Posted By Helmwurst

Is there a number etched or stamped on the...

Is there a number etched or stamped on the lock?If so, you can call them and they will get you a key. That drive is heavy, better use a lift of some sort.
11-10-2021, 07:12 AM
Replies: 26
Views: 769
Posted By resurrected

Yes it will just slide out, be gentle with the...

Yes it will just slide out, be gentle with the alignment of the cardan joint through the helmet, its pretty tight.
Can't help with the lock nut.
11-09-2021, 01:12 PM
Replies: 26
Views: 769
Posted By cigrocket

To remove Mcgaurd lock Cut Ring with a...

To remove Mcgaurd lock

Cut Ring with a dremel with a cut off wheel and made 2 cuts thru the sleeve as deep as possible, then just split the sleeve off with a screw driver. Then just knock a socket...
11-09-2021, 12:35 PM
Replies: 26
Views: 769
Posted By bob

I have also replaced them on the boat. PIA but...

I have also replaced them on the boat. PIA but it can be done.
11-09-2021, 07:10 AM
Replies: 26
Views: 769
Posted By resurrected

That hose take a ton of abuse for what it is....

That hose take a ton of abuse for what it is. Pain in the butt to replace. Taking the drive off is easy, so is installing it if you have the guide spring in the tail stock (which I don't).
I used an...
11-06-2021, 09:11 AM
Replies: 5
Views: 428
Posted By cig28

Scippy call Craig colabella he is the man when it...

Scippy call Craig colabella he is the man when it comes to all speedmaster drives. https://www.colabellaperformance.com/
11-05-2021, 01:29 PM
Replies: 5
Views: 428
Posted By whiplash22

Galen died a couple years ago. Tina was looking...

Galen died a couple years ago. Tina was looking to sell the business and did sell some of the tools. I know she was talking to Weisman and he was going to set up a shop in Sarasota but I don't think...
Forum: Scarab
11-02-2021, 02:10 AM
Replies: 3
Views: 534
Posted By larslindroth

Larry Smith's personal ex. 1987 Team Scarab 38.

Larry's boat deserves its own thread. That our legendary hero owned his twin diesel Scarab 48 for about 10 years is pretty much common knowledge, but which Team Scarab boats

did he build for...
11-01-2021, 12:16 PM
Replies: 26
Views: 769
Posted By TomFTM

are u sure its not oil from the trim cylinders ....

are u sure its not oil from the trim cylinders . the seals like to dry out and leak . they also sometimes develop pin hole leaks in the outer case. I have seen them leak numerous times on ssm...
Forum: Scarab
10-26-2021, 10:08 AM
Replies: 1,247
Views: 410,327
Posted By hblair

I put the hatches together and sat them in place....

I put the hatches together and sat them in place. Not installed yet. They look pretty close to original. Kind of a dull nickel plated look. Also Billy has been working on the trailer. Few coats of...
Forum: Cigarette
10-19-2021, 11:32 AM
Replies: 13
Views: 1,476
Posted By Metalguy38

Boat vs. land investment. Cig for sale?

Gents,

ive got an opportunity to buy my neighbors 60 acres under market value. in an effort to keep developers away from our quiet 40 acre ranch I’m thinkkng about selling my Cig...

1989 20th...
Forum: Cigarette
10-19-2021, 07:44 AM
Replies: 10
Views: 1,392
Posted By Full Force

Been a nice run, sold the gun...

Sad to report I sold my top gun, the second drive this summer helped push me over edge and looked at the money I'm spending to just go boating, having grandkids now and a father that needs to go...
10-16-2021, 09:48 PM
Replies: 121
Views: 34,038
Posted By rak rua

Difficult to track down “American Eagle”, after...

Difficult to track down “American Eagle”, after moving to Australia, she had a few different owners. I’m not sure of the exact order but it became Whippys Eagle (Owner Brian ‘Whippy’ Stevens) The...
10-16-2021, 03:14 PM
Replies: 121
Views: 34,038
Posted By larslindroth

The Cigarette is a 32' and ex. Tom Genry's...

The Cigarette is a 32' and ex. Tom Genry's American Eagle is a 36'.
...
10-15-2021, 09:00 AM
Replies: 121
Views: 34,038
Posted By auxiliary_power

https://cimg5.ibsrv.net/gimg/www.offshoreonly.com-...

https://cimg5.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/1522x1080/american_eagle_the_cigarette_c36c6b7c2ae5650f8588385e98eb4de099d81b39.jpg
American Eagle (Arnold Glass) & The CIGARETTE (Norm...
Forum: Apache
10-08-2021, 10:10 AM
Replies: 21
Views: 2,459
Posted By kreed

Warlord

Bout 4 yrs ago I went upstate NY to buy a Top Gun with a buddy… we walked into the guys garage and sitting there was Warlord! He was nice enough to let me climb all over it… real cool boat....
Forum: Superboat
09-09-2021, 10:28 AM
Replies: 7
Views: 500
Posted By nhrafreak92

New to me 24 ft Superboat

Just picked up this 1996 24 superboat last Friday. It’s in phenomenal shape, I love it so far! It was previously owned by a few forum members. Here are some pictures. I’m glad to join the Superboat...
08-19-2021, 06:29 PM
Replies: 19
Views: 1,886
Posted By hoodoo

Hell may be a little harsh but that’s not my cup...

Hell may be a little harsh but that’s not my cup of tea.
However, a Trump boat parade would be HEAVEN right now.
08-18-2021, 03:50 PM
Replies: 2
Views: 466
Posted By larslindroth

Let's cheer Chip on to load up the final video(s)...

Let's cheer Chip on to load up the final video(s) of his Magnum resto. 'Project Dreamboat' kind of episodes:

https://www.youtube.com/watch?v=ZMUImXo_aPY&t=8s
...
Showing results 1 to 25 of 288
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.