Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Rookie
Showing results 1 to 25 of 500
Search took 0.11 seconds.
Forum: General Q & A
Yesterday, 06:11 PM
Replies: 2
Views: 122
Posted By Rookie

If the filter head is above the pump I see no...

If the filter head is above the pump I see no issue pulling fuel through the cooler. I assume currently there is not an issue with the pump drawing through the filter.
Forum: General Q & A
09-29-2022, 10:15 AM
Replies: 45
Views: 9,714
Posted By Rookie

Not Optima blues. I have a stack of those...

Not Optima blues. I have a stack of those worthless things. I have had excellent luck Walmart Everstart Maxx (Johnson Controls) group 29 and 31 marine batteries. Tried Optimas for my cruiser and my...
Forum: General Q & A
09-28-2022, 08:12 PM
Replies: 7
Views: 201
Posted By Rookie

I like my mechanical Bluewater indicators. They...

I like my mechanical Bluewater indicators. They are also reasonably prices compared to others.
https://www.marineindustrieswest.com/BluewaterMechanicalIndicators.htm
09-25-2022, 05:31 PM
Replies: 29
Views: 2,306
Posted By Rookie

My friends 45 with triple 454-370's was a thirsty...

My friends 45 with triple 454-370's was a thirsty girl. Definitely would be a great diesel conversion. Maybe quad Cumminns or Duramax in the 500HP range.
09-25-2022, 11:12 AM
Replies: 38
Views: 7,696
Posted By Rookie

Yeah, I believe that is where my 15 switches...

Yeah, I believe that is where my 15 switches turned into 21. Lol
Forum: Powerquest
09-24-2022, 09:05 PM
Replies: 5
Views: 131
Posted By Rookie

Just run your 24's to get a base line and go from...

Just run your 24's to get a base line and go from there. If you increase your horsepower your will need to increase your target RPM. What are your HP/TQ peaks from the dyno or engine builder? Also,...
09-24-2022, 08:36 PM
Replies: 38
Views: 7,696
Posted By Rookie

I'm currently flush mounting my digital dash ...

I'm currently flush mounting my digital dash
https://cimg7.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/592x446/20220813_145945_2ea3d23679795a73772cfee01c01f67cb303864c.jpg
es.
09-24-2022, 08:34 PM
Replies: 38
Views: 7,696
Posted By Rookie

I'm making a new dash as we speak. I just did...

I'm making a new dash as we speak. I just did separate switches for my nav light up and down (momentary switches) and individual for bilge. The Manual bilge is a momentary switch and automatic bilge...
Forum: General Q & A
09-21-2022, 09:23 AM
Replies: 15
Views: 508
Posted By Rookie

I use these cheap O2 extenders. They were...

I use these cheap O2 extenders. They were consistent with using no extender on the dyno....
Forum: General Q & A
09-20-2022, 05:08 PM
Replies: 15
Views: 508
Posted By Rookie

Here's the location on mine. It's in the tail...

Here's the location on mine. It's in the tail pipe right after the collector about 2:00...
Forum: General Q & A
09-13-2022, 11:01 PM
Replies: 5
Views: 332
Posted By Rookie

Pencil anodes are like $12. Magnesium for fresh...

Pencil anodes are like $12. Magnesium for fresh water and zinc for salt/brackish. Put them in the intake or heads.
Forum: Powerquest
09-13-2022, 07:51 PM
Replies: 21
Views: 1,819
Posted By Rookie

What gear ratio are your drives? 50 @ 3500?...

What gear ratio are your drives? 50 @ 3500? That's impressive for that hull with only a 24 pitch. What HP are the current engines?
09-09-2022, 09:04 AM
Replies: 72
Views: 2,912
Posted By Rookie

How was it ran on the dyno?

How was it ran on the dyno?
09-08-2022, 09:39 PM
Replies: 72
Views: 2,912
Posted By Rookie

Yes, I am referring to Jim's old boat. I believe...

Yes, I am referring to Jim's old boat. I believe he ran a labbed 28 Bravo 1.
09-08-2022, 08:20 PM
Replies: 8
Views: 1,641
Posted By Rookie

That's funny. When my AT was getting painted, my...

That's funny. When my AT was getting painted, my painter said that he was a taper that happened to also paint. He'd spend days laying vinyl down and picking tape to spray for 5-20 mins.
09-08-2022, 08:15 PM
Replies: 72
Views: 2,912
Posted By Rookie

I skimmed through this thread and couldn't find...

I skimmed through this thread and couldn't find what exhaust and flame arrestor you are running vs dyno trim. Unless you were running full marine trim on the dyno.
Also, my friends 27' I use to run...
09-07-2022, 10:21 AM
Replies: 72
Views: 2,912
Posted By Rookie

A 27' with a 540 should easily run 80. Stepped or...

A 27' with a 540 should easily run 80. Stepped or non-stepped hull? Didn't they run 69 mph wit a stock 370HP?
I know the 27' that I have driven was dialed in pretty good, but it is a fast hull.
Forum: Electronics
09-05-2022, 06:14 PM
Replies: 18
Views: 650
Posted By Rookie

Get the Holley dual sync and run CNP. By the time...

Get the Holley dual sync and run CNP. By the time you purchase distributor, ignition box and coil you can go CNP for the same or less cost. Here is a link to my conversion....
Forum: Wanted
09-04-2022, 08:27 PM
Replies: 5
Views: 324
Posted By Rookie

What diameter are you looking for? I believe I...

What diameter are you looking for? I believe I have one laying around, but I think it was for a Bravo boat. Maybe 13/16" thread LH-RH,
Forum: General Q & A
09-04-2022, 09:53 AM
Replies: 5
Views: 182
Posted By Rookie

I had a trim pump that would not do anything,...

I had a trim pump that would not do anything, Make a noise or want to move. The brushes were corroded so bad that there was no contact and and they did not move freely. Damn saltwater boat! I took...
Forum: General Q & A
09-03-2022, 09:38 AM
Replies: 5
Views: 182
Posted By Rookie

I assume it is the hydraulic seat?? Probably just...

I assume it is the hydraulic seat?? Probably just need to clean the terminals on the pump.
Forum: General Q & A
08-30-2022, 09:12 AM
Replies: 18
Views: 660
Posted By Rookie

Just pointing out what it shows. I know the...

Just pointing out what it shows. I know the before and after numbers.
Forum: General Q & A
08-29-2022, 09:34 PM
Replies: 18
Views: 660
Posted By Rookie

Moisture meter from Home Depot corresponded with...

Moisture meter from Home Depot corresponded with "pin" marine moisture meter. Known bad parts of the transom were 20-26%. Spots away from bolts and fittings were 8-12%. New transom and stringers...
Forum: General Q & A
08-26-2022, 08:41 AM
Replies: 13
Views: 387
Posted By Rookie

Before of after cooler? I don't know where they...

Before of after cooler? I don't know where they are located.
And 220°F is a no go for me after the cooler.
Forum: General Q & A
08-22-2022, 09:04 PM
Replies: 19
Views: 665
Posted By Rookie

I don't worry about idle AFR. I know it's usually...

I don't worry about idle AFR. I know it's usually high close to 14. Just as long as it idles. Where ever it falls I live with it.
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.