Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: sailtexas186548
Showing results 1 to 25 of 356
Search took 0.01 seconds.
09-14-2021, 05:22 PM
Replies: 128
Views: 10,295
Posted By sailtexas186548

Hagerty wonít touch something over 28í and 20+...

Hagerty wonít touch something over 28í and 20+ years old. Thatís the cut off on a lot of insurers. They offered me boat coverage after insuring some of my cars and promptly said ďnoĒ when they found...
09-03-2021, 07:37 PM
Replies: 128
Views: 10,295
Posted By sailtexas186548

Hopefully not to the Middle East never to be seen...

Hopefully not to the Middle East never to be seen again
07-27-2021, 09:28 PM
Replies: 20
Views: 1,399
Posted By sailtexas186548

I think itís great, the fishing boat guys are...

I think itís great, the fishing boat guys are gonna put a hurting on everybody in the enduro races
Forum: Scarab
07-19-2021, 11:48 AM
Replies: 13
Views: 591
Posted By sailtexas186548

yup, through the drain plug or through hull into...

yup, through the drain plug or through hull into a container.
Forum: Scarab
07-19-2021, 11:44 AM
Replies: 13
Views: 591
Posted By sailtexas186548

I use a carter electric fuel pump connected to...

I use a carter electric fuel pump connected to the fuel pickup, wired to a 12v battery. IMO your tanks would have to be really nasty or damaged to warrant pulling them vs flushing/polishing the fuel...
Forum: Scarab
07-18-2021, 09:13 PM
Replies: 13
Views: 591
Posted By sailtexas186548

Some solvent and a trailer ride to slosh it,...

Some solvent and a trailer ride to slosh it, drain, and repeat a couple times can really clean it up. Then rig up a fuel polishing setup.
Forum: Cigarette
07-10-2021, 08:06 AM
Replies: 55
Views: 4,568
Posted By sailtexas186548

Hard to believe bad gas damaged a valve like that...

Hard to believe bad gas damaged a valve like that unless all of the pistons show knock damage also, what does the knock sensor data show? That was probably a flawed valve IMO
07-07-2021, 05:28 PM
Replies: 1,291
Views: 331,417
Posted By sailtexas186548

Man if you find where to get new bronze/copper...

Man if you find where to get new bronze/copper caps that is the wayt o go. If you find where to buy some please post up, I have a "Savage" brand cooler with these caps that were cracked and I had to...
07-05-2021, 12:21 PM
Replies: 49
Views: 4,812
Posted By sailtexas186548

I believe boats stored outside, covered or not,...

I believe boats stored outside, covered or not, are the highest potential for rotten wood especially if they are in a high humidity/rainfall region. Same deal with cars
07-02-2021, 05:10 PM
Replies: 53
Views: 8,080
Posted By sailtexas186548

looking good

looking good
07-01-2021, 09:49 PM
Replies: 9
Views: 577
Posted By sailtexas186548

I would mask the critical fits like bearings

I would mask the critical fits like bearings
Forum: General Q & A
06-22-2021, 09:04 PM
Replies: 14
Views: 731
Posted By sailtexas186548

Iím looking at stack injection also, it is big $...

Iím looking at stack injection also, it is big $ to buy the nice stuff.
06-19-2021, 11:30 AM
Replies: 2
Views: 270
Posted By sailtexas186548

Subscribed. Anything special for coosa/Penske Vs...

Subscribed. Anything special for coosa/Penske Vs wood for those who know?
Forum: General Q & A
06-05-2021, 11:09 PM
Replies: 6
Views: 767
Posted By sailtexas186548

it does not need to be upside down, yes the one...

it does not need to be upside down, yes the one pieces are good, sealant in corners per the gel pro instructions
06-04-2021, 09:28 PM
Replies: 20
Views: 1,809
Posted By sailtexas186548

I used flexible LED strips from PlashLights on my...

I used flexible LED strips from PlashLights on my fishing boat trailer, much higher quality than the cheap eBay strips. They come in red, blue, green, and white, or RGB which requires the Bluetooth...
06-03-2021, 11:41 AM
Replies: 3
Views: 1,192
Posted By sailtexas186548

The no wake zone for the shootout was requested...

The no wake zone for the shootout was requested this week from the local municipalities Friday 8am to noon. My city approved it and I assume the others did also, so the shootout should be happening...
Forum: General Q & A
06-02-2021, 07:40 PM
Replies: 6
Views: 767
Posted By sailtexas186548

Pan off, new seals and gaskets, prime oil pump...

Pan off, new seals and gaskets, prime oil pump with drill, fire it up! I have a 1946 flathead that sat for ten years (running when I parked it!), all I did was change the oil and rebuild the carb,...
Forum: General Q & A
06-01-2021, 05:49 PM
Replies: 16
Views: 1,082
Posted By sailtexas186548

the ME is a ceramic foam, itís basically sanding...

the ME is a ceramic foam, itís basically sanding with fine sandpaper. I would be careful using that on vinyls, it probably ďcleansĒ by taking off the top layer of the material
Forum: General Q & A
05-30-2021, 10:38 AM
Replies: 14
Views: 8,465
Posted By sailtexas186548

If your engine bay is well ventilated you could...

If your engine bay is well ventilated you could probably just run a fan on the automotive condenser mounted inside the bay
Forum: General Q & A
05-30-2021, 10:35 AM
Replies: 24
Views: 2,731
Posted By sailtexas186548

I would think a vintage air system with a...

I would think a vintage air system with a modified heat exchanger to use raw water from the engine system in place of the air cooled automotive one would be pretty easy to make work. I plan to build...
Forum: General Q & A
05-19-2021, 05:46 PM
Replies: 31
Views: 2,659
Posted By sailtexas186548

I use an oil extractor (dedicated to antifreeze)...

I use an oil extractor (dedicated to antifreeze) to suck the coolant level way down before I remove the intake or heads, I keep the coolant in a 5 gallon bucket to reuse. My block drains are too hard...
05-10-2021, 09:21 PM
Replies: 29
Views: 4,356
Posted By sailtexas186548

While no response isnít great, taking in your...

While no response isnít great, taking in your props knowing they canít get to them anytime soon is worse. Itís a tough world right now
05-09-2021, 09:26 PM
Replies: 4
Views: 679
Posted By sailtexas186548

I think he is asking spinning In or out

I think he is asking spinning In or out
Forum: Scarab
05-09-2021, 01:07 PM
Replies: 1,222
Views: 387,451
Posted By sailtexas186548

Looking good

Looking good
Showing results 1 to 25 of 356
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.