Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: snapmorgan
Showing results 1 to 25 of 116
Search took 0.01 seconds.
Forum: General Q & A
08-02-2022, 01:44 PM
Replies: 158
Views: 3,579
Posted By snapmorgan

I don't understand why you would swap some...

I don't understand why you would swap some suspect coils to another cylinder to try them out. Just put your inline spark tester on them and see if they work.
07-11-2022, 01:56 PM
Replies: 134
Views: 3,699
Posted By snapmorgan

You will probably see why it got so hot when you...

You will probably see why it got so hot when you pull the head off to replace the piston. My bet is that the piston is melted and the head gasket blown between cylinders
07-05-2022, 09:09 AM
Replies: 29
Views: 1,435
Posted By snapmorgan

Yes, same yoke

Yes, same yoke
06-30-2022, 09:49 AM
Replies: 134
Views: 3,699
Posted By snapmorgan

I would bet that for a couple of round trip plane...

I would bet that for a couple of round trip plane tickets and a week lodging, any number of us would come get it lined out for you.
Forum: General Q & A
06-22-2022, 01:35 PM
Replies: 55
Views: 1,521
Posted By snapmorgan

The worst that could happen is that you would...

The worst that could happen is that you would have to pull the engine again, replace the bearings and polish the crank, probably replace some stuck lifters and so on. Makes an oil cooler look pretty...
Forum: General Q & A
06-22-2022, 07:54 AM
Replies: 55
Views: 1,521
Posted By snapmorgan

I would suggest replacing the oil cooler on the...

I would suggest replacing the oil cooler on the engine with the failed cam. There is no way of getting all of the fine metal particles out of it by cleaning.
Forum: General Q & A
06-15-2022, 01:24 PM
Replies: 9
Views: 450
Posted By snapmorgan

Time to open them up and take a look. Probably...

Time to open them up and take a look. Probably flaking off of the teeth
Forum: General Q & A
05-25-2022, 08:32 PM
Replies: 36
Views: 2,270
Posted By snapmorgan

I carried a spare XR drive in the bed of my truck...

I carried a spare XR drive in the bed of my truck for years. I used it a couple of times on my own boats, but it did get loaned out a lot too. It was a money maker as well. I would let them use my...
05-16-2022, 11:53 AM
Replies: 20
Views: 1,631
Posted By snapmorgan

I can take a look at them if need be. Not sure...

I can take a look at them if need be. Not sure what you are looking at, but i can do a compression and leakdown on them if needed
Forum: General Q & A
05-04-2022, 01:34 PM
Replies: 10
Views: 859
Posted By snapmorgan

It really doesn't matter how many amps that you...

It really doesn't matter how many amps that you throw at a battery, It will only absorb it so fast. It takes hours to charge a battery that is 75% charged and sometimes days to charge a battery that...
Forum: General Q & A
05-03-2022, 03:14 PM
Replies: 19
Views: 833
Posted By snapmorgan

12" was always the magic number on dry sump oil...

12" was always the magic number on dry sump oil systems in the race cars.
Forum: General Q & A
04-25-2022, 09:18 AM
Replies: 13
Views: 635
Posted By snapmorgan

I have always ran them back to the tank without...

I have always ran them back to the tank without issue. I had a 454 mag MPI years ago that would vapor lock almost every time it was hot outside. I pulled the return off of the filter head and ran it...
Forum: Formula
04-21-2022, 01:57 PM
Replies: 38
Views: 6,764
Posted By snapmorgan

I have said it on here many times. Full hydraulic...

I have said it on here many times. Full hydraulic steering is the single best upgrade you can do to a boat and is a necessity on any boat that runs over about 60mph.
Forum: General Q & A
04-18-2022, 01:22 PM
Replies: 21
Views: 1,108
Posted By snapmorgan

Probably easier to drill and tap the heads to the...

Probably easier to drill and tap the heads to the conventional bolt pattern
Forum: General Q & A
04-15-2022, 01:09 PM
Replies: 24
Views: 1,117
Posted By snapmorgan

I had SM gen 3's on a 900+hp engine and they...

I had SM gen 3's on a 900+hp engine and they worked fine. I put O2 bungs in the tails without problem
Forum: General Q & A
03-31-2022, 08:10 AM
Replies: 18
Views: 1,225
Posted By snapmorgan

Back in my dirt racing days it was always a...

Back in my dirt racing days it was always a struggle to keep the oil in the aluminum Rodeck blocks. Pan rails were ground out for crank and rod clearance, oil pans were modified and so on. I finally...
02-17-2022, 01:58 PM
Replies: 39
Views: 3,578
Posted By snapmorgan

Maybe some of these have been built off the...

Maybe some of these have been built off the radar, but I only remember about 5 of these being built so far. I got to ride in the orange one, which I believe was the first one built. What a wonderful...
Forum: General Q & A
02-11-2022, 01:53 PM
Replies: 18
Views: 1,844
Posted By snapmorgan

I modified a 250 chiller to fit a 420 pretty...

I modified a 250 chiller to fit a 420 pretty easily, just had to drill and tap a couple of holes. If you can find one for a 420 it should work with a little modification
01-31-2022, 07:43 AM
Replies: 25
Views: 2,058
Posted By snapmorgan

My 35 with 700's averaged about 1.2mpg, but they...

My 35 with 700's averaged about 1.2mpg, but they didn't do that at 100mph
Forum: Southeast US
01-19-2022, 09:29 AM
Replies: 3
Views: 691
Posted By snapmorgan

I can do it for you if you can't find anyone. Is...

I can do it for you if you can't find anyone. Is the boat on a lift or trailer?
Forum: General Q & A
01-06-2022, 01:08 PM
Replies: 53
Views: 3,050
Posted By snapmorgan

Even though the bolts are below the surface, it...

Even though the bolts are below the surface, it is a very easy job to build them up with a mig welder and weld a nut to them to remove them.
Forum: General Q & A
01-05-2022, 09:24 AM
Replies: 8
Views: 339
Posted By snapmorgan

Nearly all boats are set up with PS on only one...

Nearly all boats are set up with PS on only one engine. If that engine dies, you can still steer, it just doesn't have power assist.
Forum: General Q & A
01-05-2022, 07:22 AM
Replies: 8
Views: 339
Posted By snapmorgan

Are you saying that you have the half system that...

Are you saying that you have the half system that still uses the cable helm? If so, get a hydraulic helm and run the lines to make it full hydraulic. You won't regret it.
Forum: General Q & A
01-05-2022, 07:15 AM
Replies: 24
Views: 2,003
Posted By snapmorgan

https://www.summitracing.com/parts/nal-12371056?se...

https://www.summitracing.com/parts/nal-12371056?seid=srese1&gclid=EAIaIQobChMIrZbpntia9QIVFXmGCh0xPQLfEAQYBSABEgIkF_D_BwE

This is what I have always used on gen6 engines. There is no reason to...
01-04-2022, 07:45 AM
Replies: 82
Views: 7,714
Posted By snapmorgan

You won't save any money with Marine Kinetics. He...

You won't save any money with Marine Kinetics. He has every part drop shipped from the manufacturer and you end up paying as much for shipping as you do for the parts. At least that's what happened...
Showing results 1 to 25 of 116
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.