Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: snapmorgan
Showing results 1 to 25 of 500
Search took 0.07 seconds.
Forum: Sonic
08-04-2022, 02:09 PM
Replies: 23
Views: 1,545
Posted By snapmorgan

Full hydraulic steering is the single best...

Full hydraulic steering is the single best improvement you can do to a boat. I would never own a boat without it again.
08-02-2022, 01:46 PM
Replies: 28
Views: 27,221
Posted By snapmorgan

I believe that I have one in my toolbox at home....

I believe that I have one in my toolbox at home. I will check this evening
Forum: General Q & A
08-02-2022, 01:44 PM
Replies: 158
Views: 3,579
Posted By snapmorgan

I don't understand why you would swap some...

I don't understand why you would swap some suspect coils to another cylinder to try them out. Just put your inline spark tester on them and see if they work.
08-02-2022, 08:51 AM
Replies: 11
Views: 452
Posted By snapmorgan

Johnson Engines in Harrisburgh IL specializes in...

Johnson Engines in Harrisburgh IL specializes in 7.3's. I used to buy parts from them from time to time when I needed a head or rods. Might give them a shout
Forum: General Q & A
07-11-2022, 02:02 PM
Replies: 158
Views: 3,579
Posted By snapmorgan

Start with the basics. Plugs, wires, fuel filters...

Start with the basics. Plugs, wires, fuel filters and a compression test. Verify that all cylinders are firing with a spark tester and report back
07-11-2022, 01:56 PM
Replies: 134
Views: 3,699
Posted By snapmorgan

You will probably see why it got so hot when you...

You will probably see why it got so hot when you pull the head off to replace the piston. My bet is that the piston is melted and the head gasket blown between cylinders
07-08-2022, 09:32 AM
Replies: 31
Views: 1,576
Posted By snapmorgan

I had a 35 Nordic for 3 or 4 seasons. It was a...

I had a 35 Nordic for 3 or 4 seasons. It was a nice boat. Ran good, handled good. It ran mid 90's. Build quality was OK, certainly way better than a Fountain, probably about the same as a Sunsation,...
Forum: General Q & A
07-06-2022, 02:03 PM
Replies: 14
Views: 620
Posted By snapmorgan

Ateco Engine & Dyno Shop | Automotive & Marine...

Ateco Engine & Dyno Shop | Automotive & Marine Engines (atecoengines.com) (https://atecoengines.com/)
07-05-2022, 09:09 AM
Replies: 29
Views: 1,435
Posted By snapmorgan

Yes, same yoke

Yes, same yoke
07-05-2022, 07:51 AM
Replies: 16
Views: 1,109
Posted By snapmorgan

A few years ago, I sold a 28' Advantage with a...

A few years ago, I sold a 28' Advantage with a single 700 and bought a 35' Nordic with twin 700's. Fuel burn was almost identical between the two. Hindsight being 20/20, I personally prefer the...
06-30-2022, 09:08 PM
Replies: 134
Views: 3,699
Posted By snapmorgan

Yes, 3/4 turn after 0 lash

Yes, 3/4 turn after 0 lash
06-30-2022, 09:49 AM
Replies: 134
Views: 3,699
Posted By snapmorgan

I would bet that for a couple of round trip plane...

I would bet that for a couple of round trip plane tickets and a week lodging, any number of us would come get it lined out for you.
Forum: General Q & A
06-22-2022, 01:35 PM
Replies: 55
Views: 1,521
Posted By snapmorgan

The worst that could happen is that you would...

The worst that could happen is that you would have to pull the engine again, replace the bearings and polish the crank, probably replace some stuck lifters and so on. Makes an oil cooler look pretty...
Forum: General Q & A
06-22-2022, 07:54 AM
Replies: 55
Views: 1,521
Posted By snapmorgan

I would suggest replacing the oil cooler on the...

I would suggest replacing the oil cooler on the engine with the failed cam. There is no way of getting all of the fine metal particles out of it by cleaning.
Forum: General Q & A
06-17-2022, 01:09 PM
Replies: 26
Views: 1,259
Posted By snapmorgan

I know this is not the same, BUT, not too many...

I know this is not the same, BUT, not too many years ago I ran dirt track cars in a class that was limited to flat tappet cams. Big solid cams and big springs, 7500rpm. Here was the cam break in...
Forum: General Q & A
06-15-2022, 01:24 PM
Replies: 9
Views: 450
Posted By snapmorgan

Time to open them up and take a look. Probably...

Time to open them up and take a look. Probably flaking off of the teeth
Forum: General Q & A
06-13-2022, 12:12 PM
Replies: 36
Views: 2,270
Posted By snapmorgan

I have had 2 instances where delayed engagement...

I have had 2 instances where delayed engagement started after switching to Amsoil. Both instances the cone clutch was worn out. Put in new clutches and the delayed engagement went away. Amsoil must...
Forum: General Q & A
05-25-2022, 08:32 PM
Replies: 36
Views: 2,270
Posted By snapmorgan

I carried a spare XR drive in the bed of my truck...

I carried a spare XR drive in the bed of my truck for years. I used it a couple of times on my own boats, but it did get loaned out a lot too. It was a money maker as well. I would let them use my...
Forum: General Q & A
05-25-2022, 07:49 AM
Replies: 32
Views: 1,047
Posted By snapmorgan

Have you checked the distributor cap and rotor?...

Have you checked the distributor cap and rotor? Those GM EST caps and rotors will barely make it a season before corroding up badly.
Forum: General Q & A
05-23-2022, 01:26 PM
Replies: 16
Views: 550
Posted By snapmorgan

12.4V is only about 75% charged. Leave volt meter...

12.4V is only about 75% charged. Leave volt meter attached to battery while cranking and see what it reads. It shouldn't drop below about 10V
Forum: General Q & A
05-17-2022, 08:56 AM
Replies: 6
Views: 396
Posted By snapmorgan

. i was going to put a breakover bar and socket...

. i was going to put a breakover bar and socket on the harmonic balance but the bolt is rusted so much as to not have shoulders that a socket would go on.


If the balancer bolt is rusted away, I...
05-16-2022, 01:44 PM
Replies: 51
Views: 25,439
Posted By snapmorgan

No longer have it

No longer have it
05-16-2022, 11:53 AM
Replies: 20
Views: 1,631
Posted By snapmorgan

I can take a look at them if need be. Not sure...

I can take a look at them if need be. Not sure what you are looking at, but i can do a compression and leakdown on them if needed
Forum: Fountain
05-09-2022, 09:23 AM
Replies: 10
Views: 829
Posted By snapmorgan

The 32's sit really low in the back. They always...

The 32's sit really low in the back. They always look like they are sinking.
05-05-2022, 09:41 AM
Replies: 141
Views: 11,199
Posted By snapmorgan

The agent actually sold me the policy and it was...

The agent actually sold me the policy and it was kicked back about a month later by corporate with a letter stating that.
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.