Go Back  Offshoreonly.com > Search Forums
Reload this Page > Search Results
 
Search: Posts Made By: Clustergear
Showing results 1 to 25 of 410
Search took 0.10 seconds.
04-26-2018, 07:56 AM
Replies: 14
Views: 554
Posted By Clustergear

Iím from DobbsFerry moved up here after I retired.

Iím from DobbsFerry moved up here after I retired.
04-26-2018, 06:33 AM
Replies: 14
Views: 554
Posted By Clustergear

Yes I would try swap too. The reason I brought...

Yes I would try swap too. The reason I brought this up is I have run into this before. With drive off there was no noise, with drive on and in the full down position rattling noise. Guessing the back...
04-25-2018, 06:19 PM
Replies: 14
Views: 554
Posted By Clustergear

I watched video but my old deaf ears can’t hear...

I watched video but my old deaf ears can’t hear it. Do you have a y pipe on motors, The flappers in y pipes get burned and the metal rod falls down inside pipe and makes a rattle at ldle but...
Forum: General Q & A
04-24-2018, 06:45 AM
Replies: 3
Views: 177
Posted By Clustergear

Here’s the rubber latches....

Here’s the rubber latches. https://www.amazon.com/gp/product/B004APJRMS/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1
03-23-2018, 09:28 PM
Replies: 5
Views: 338
Posted By Clustergear

You might want to get upper seal kit, load ring...

You might want to get upper seal kit, load ring and instead of getting lower seal kit as it comes with many parts you donít need just get four o rings and two prop shaft seals for lower. Other than...
03-23-2018, 09:00 PM
Replies: 5
Views: 338
Posted By Clustergear

Look for piting on gears ( rough spots on gear...

Look for piting on gears ( rough spots on gear teeth face ) look for cracks on teeth. On driven gear bearings and tower bearings use small screw to spred needle bearing to check for excessive spacing...
03-05-2018, 06:50 AM
Replies: 15
Views: 1,332
Posted By Clustergear

If you have DWP on your lower and a someone to...

If you have DWP on your lower and a someone to help you. While drive is dry place tape on lower water pick up and muffs on side pick ups. As you start motor have other person turn water on. ...
02-23-2018, 12:27 PM
Replies: 8
Views: 309
Posted By Clustergear

OK if I remember correctly 11 came out in 1989...

OK if I remember correctly 11 came out in 1989 and 28 came out in 2003. 28 will be more up to date and is the one I use the most. It will cover old the older models. Not sure if 28 has anything...
02-22-2018, 06:15 PM
Replies: 8
Views: 309
Posted By Clustergear

If I remember correctly 11 was the first Bravo...

If I remember correctly 11 was the first Bravo manual if your looking to get a manual get 28 itís updated there are also two supplements to 28 for the newer bravoís
02-02-2018, 05:03 PM
Replies: 1
Views: 332
Posted By Clustergear

Bravo l driven gear bearing

Has any one used the Koyo B-3214 needle bearing available on Amazon in driven gears on Bravo l upper.
01-18-2018, 05:59 PM
Replies: 8
Views: 483
Posted By Clustergear

just put a little silicone on outer part of the...

just put a little silicone on outer part of the resivoir seal so it seals just like the o ring on bell housing would seal it. Not to much you donít want the silicone to push ball in. There is a...
Forum: Fountain
01-11-2018, 07:16 PM
Replies: 13
Views: 859
Posted By Clustergear

I had the same problem, so I bought the house...

I had the same problem, so I bought the house next door and built the building behind that house. Problem solved
Forum: Fountain
01-11-2018, 06:44 PM
Replies: 13
Views: 859
Posted By Clustergear

I have 45x45 with 12w X10h doors I have a bay on...

I have 45x45 with 12w X10h doors I have a bay on the side that has 10w X 8h that I keep boat in. My 27 Fountain on a Mico with torsion axle fits fine. My old 33Powerplay was right at the 8 ft and...
01-06-2018, 08:26 PM
Replies: 5
Views: 403
Posted By Clustergear

Fire away

Fire away
01-06-2018, 08:00 AM
Replies: 5
Views: 403
Posted By Clustergear

888

The 888 drive is a MC1. Itís the pre MR. They donít like anything near or over 300 hp. They had small pinion and thin gear. But Mercury came out with some heavier lower gear sets around 1980 for...
Forum: Wanted
12-26-2017, 12:09 PM
Replies: 18
Views: 781
Posted By Clustergear

sent the pictures of cap I have. Though it was...

sent the pictures of cap I have. Though it was Bravo l. Itís got 5 holes itís for Imco upper
Forum: Wanted
12-25-2017, 10:43 AM
Replies: 18
Views: 781
Posted By Clustergear

Itís under IMCO outdrive....

Itís under IMCO outdrive. https://www.ebay.com/itm/Imco-Steering-Wing-Plate-Drive-End-Cap-Outdrive/152814831719?hash=item2394794867:g:Ii0AAOSw9mpaJaJn&vxp=mtr
Forum: Wanted
12-25-2017, 07:05 AM
Replies: 18
Views: 781
Posted By Clustergear

I have one if interested PM with email Iíll sent...

I have one if interested PM with email Iíll sent pictures of the one I have
12-04-2017, 12:57 PM
Replies: 29
Views: 1,532
Posted By Clustergear

Yes All looked same as originals, red ones...

Yes All looked same as originals, red ones replaced with red and white one replaced with white. New ones have stainless steel pull pin not plastic like old ones. The trigger is a sealed unit, you no...
12-03-2017, 08:51 PM
Replies: 29
Views: 1,532
Posted By Clustergear

I have six that were on the recall. I have...

I have six that were on the recall. I have received six replacements from Kidde they came in separate boxes. Just take new one out put old one in the box, put return label on box. Call Fex Ex and...
11-29-2017, 06:50 AM
Replies: 18
Views: 1,046
Posted By Clustergear

CDL and Data Logger info

Hope this link works. There have been many posts about who needs a CDL to tow there boat trailer. This post is about horse trailers but is the same as boat trailer. This was posted on Facebook and...
10-31-2017, 06:37 PM
Replies: 4
Views: 365
Posted By Clustergear

Use wire ties, but use the good ones with...

Use wire ties, but use the good ones with stainless tab. The small T&B ones
10-09-2017, 07:59 AM
Replies: 13
Views: 913
Posted By Clustergear

it's pouring rain up here this morning. I took a...

it's pouring rain up here this morning. I took a quick look at the boat this morning. The boat looks good for its age. They did a good job cleaning off bottom paint, doesn't look like bottom is...
10-08-2017, 08:58 PM
Replies: 13
Views: 913
Posted By Clustergear

I Sent you a PM. Call me at that number

I Sent you a PM. Call me at that number
10-08-2017, 07:03 PM
Replies: 13
Views: 913
Posted By Clustergear

Danny call my cell.

Danny call my cell.
Showing results 1 to 25 of 410
 


 
Forum Jump

OSO Sponsor
OSO Advertiser
OSO Advertiser
OSO Advertiser
OSO Advertiser
OSO Advertiser
OSO Advertiser