Search: Posts Made By: nordic95
Showing results 1 to 25 of 500
Search took 0.14 seconds.
Forum: General Boating Discussion 05-31-2015, 09:58 PM
Replies: 4
Views: 535
Posted By nordic95
Boat Haul

Whats the best way to get a 32' Fountain shipped from NJ to Fayetteville AR? Anyone heading that way with open trailer? Or best rate on trucking companies.

Thanks Anthony
Forum: General Boating Discussion 11-25-2014, 09:46 PM
Replies: 5
Views: 1,168
Posted By nordic95
Here is the jack. Oil fill on top and no other...

Here is the jack. Oil fill on top and no other plugs on the jack. Looked in thru plug and oil is down about two feet. But jack works fine. I can't see filling this whole cylinder with oil.
Forum: General Boating Discussion 11-23-2014, 07:58 PM
Replies: 5
Views: 1,168
Posted By nordic95
Hein-Werner Bumper Jack

Hey guys I just purchased an old Hein Werner bumper jack and I want to make a drive installer out of it. But my question is how do I check jack oil level in this darn thing. Its air over hydraulic...
Forum: General Q & A 11-06-2014, 11:18 PM
Replies: 23
Views: 2,089
Posted By nordic95
Ok so after speaking with a few local shops I...

Ok so after speaking with a few local shops I decided to fix these heads. We used a bore scope to check as much of the ports internally as we could see and they looked fine. I had these heads milled...
Forum: General Q & A 09-12-2014, 09:49 PM
Replies: 23
Views: 2,089
Posted By nordic95
Yes it does, doesn't it... Actually not as bad as...

Yes it does, doesn't it... Actually not as bad as they appear, just bad lighting. Not really
Forum: General Q & A 09-12-2014, 09:04 PM
Replies: 23
Views: 2,089
Posted By nordic95
Can These Be Repaired ????

I need professional help.... Well, and my heads need to be examined... So does anyone with any aluminum head repair experience think these can be repaired? And if so what should it cost?


Thanks...
Forum: General Q & A 09-12-2014, 04:02 PM
Replies: 4
Views: 491
Posted By nordic95
Aluminum Head Exchange to Steel Head

So Im thinking about replacing my aluminum Edelbrock cylinder heads with steel ones. These are the 61559 rectangular port heads that had port matching and slight port work done. What would be an...
Forum: General Q & A 09-11-2014, 10:09 PM
Replies: 5
Views: 480
Posted By nordic95
Aluminum Head Repair

Hey guys Im looking for a shop that can repair a little corrosion on a set of edelbrock heads ASAP. I have them off and will strip them down bare but I will need them welded and surfaced within the...
Forum: Poker Runs and Boating Events 09-11-2014, 09:50 PM
Replies: 170
Views: 18,104
Posted By nordic95
Hey guys Im glad to see that the run will...

Hey guys Im glad to see that the run will continue. Like I said last year with my daughter racing I just wouldn't have time. And sure enough I haven't even dewinterized the boat this summer. I had a...
Forum: Northeast US 09-11-2014, 09:26 PM
Replies: 255
Views: 30,883
Posted By nordic95
Im super glad you guys are taking this on and...

Im super glad you guys are taking this on and having the run. Wish I had my boat fixed but its broken. Keep me informed on how it goes and if you need anything let me know.

Thanks Anthony
Forum: Northeast US 05-02-2014, 02:01 PM
Replies: 255
Views: 30,883
Posted By nordic95
So I just found my camera card with some video...

So I just found my camera card with some video from this run. I just threw together a ton of clips into a 33 minute video. No music or anything special but it was really cool to see and bring back...
Forum: Northeast US 05-01-2014, 08:20 PM
Replies: 6
Views: 971
Posted By nordic95
Ill trade you my boat project for a paint job on...

Ill trade you my boat project for a paint job on my 1968 firebird. then you can paint boat and do what ever you want to it....
Forum: General Q & A 04-30-2014, 08:53 PM
Replies: 17
Views: 1,568
Posted By nordic95
So I pressured test exhaust header. 15 psi of air...

So I pressured test exhaust header. 15 psi of air for two hours. It held fine. Then I went to pressure test block and instant air out the #8 spark plug hole. So I guess I know what I'm doing this...
Forum: General Q & A 04-27-2014, 06:33 PM
Replies: 17
Views: 1,568
Posted By nordic95
I did replace intake gasket today. I didn't start...

I did replace intake gasket today. I didn't start it yet but that's when I noticed water in cylinder. How does water get from intake into cylinder?.
Forum: General Q & A 04-27-2014, 02:07 PM
Replies: 17
Views: 1,568
Posted By nordic95
Bad Head Gasket or what ??? Help

OK so I have a 502 with edelbrock aluminum heads. Motor was rebuilt about 100 hours ago and 5 years ago. Motor ran great all last season and I went to winterize it I found the dreadful milkshake. Now...
Forum: Northeast US 03-11-2014, 12:35 PM
Replies: 6
Views: 971
Posted By nordic95
Perfect project for you. Mostly paint and a...

Perfect project for you. Mostly paint and a little wiring left and youll be running around the local lakes...
Forum: Northeast US 03-04-2014, 07:41 PM
Replies: 6
Views: 971
Posted By nordic95
Cougar Cub

I have a 10' cougar cub I started a full rebuild on including a custom motorized tilt trailer to look like the big boys. Lost interest and it needs to be finished. Check out my photobucket link below...
Forum: Northeast US 02-15-2014, 12:13 PM
Replies: 255
Views: 30,883
Posted By nordic95
Sorry it took so long but I just wanted to post...

Sorry it took so long but I just wanted to post the letter we received from Make-A-Wish. Like I said at the meeting we take the money from the 50/50 and donate it every year. Although it may not be a...
Forum: Northeast US 10-27-2013, 11:30 PM
Replies: 255
Views: 30,883
Posted By nordic95
I just wanted to reach out and thank everyone for...

I just wanted to reach out and thank everyone for showing up for our annual run. We couldn't have asked for a nicer day or better people to hang out with. Everyone ran great and except for a couple...
Forum: Northeast US 10-12-2013, 06:42 AM
Replies: 255
Views: 30,883
Posted By nordic95
We are loaded and heading out to marina. Everyone...

We are loaded and heading out to marina. Everyone have a safe tow and I'll see you all there.
Forum: Northeast US 10-11-2013, 08:21 PM
Replies: 255
Views: 30,883
Posted By nordic95
WTF....... 26 Boats and 71 people so far.......

WTF....... 26 Boats and 71 people so far.... WOW...I hear CD680 is buying lunch for everyone??? You did ask what you could do, remember..just kidding..


Nordic95
Forum: Northeast US 10-11-2013, 01:34 PM
Replies: 255
Views: 30,883
Posted By nordic95
If anyone wants to have this run in the spring...

If anyone wants to have this run in the spring and next fall something has to be done.
Forum: Northeast US 10-11-2013, 01:23 PM
Replies: 255
Views: 30,883
Posted By nordic95
About 120

About 120
Forum: Northeast US 10-10-2013, 10:43 PM
Replies: 255
Views: 30,883
Posted By nordic95
We are meeting at Stoney point marina about 8 am....

We are meeting at Stoney point marina about 8 am. Launching all boats and leaving marina at 11am. Heading north to Kingston for lunch around 12:30. At 3:30 we head back down river to marina. Load all...
Forum: Northeast US 10-10-2013, 01:12 PM
Replies: 255
Views: 30,883
Posted By nordic95
Also for those who have not joined us before on...

Also for those who have not joined us before on this get together a couple things you may need to know.


Its not a race. We normally cruise at about 50 mph with an occasional burst. We stop at...
Showing results 1 to 25 of 500



Forum Jump


All times are GMT -5. The time now is 12:46 AM.


Copyright 2011 OffShoreOnly. All rights reserved.