Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: ezstriper
Showing results 1 to 25 of 500
Search took 0.19 seconds.
Forum: General Q & A
10-24-2019, 10:43 AM
Replies: 5
Views: 447
Posted By ezstriper

usually you find this after engine grenaded from...

usually you find this after engine grenaded from setting the timing and the balancer had slipped 20+ degree's
Forum: General Q & A
09-11-2019, 02:56 PM
Replies: 40
Views: 2,489
Posted By ezstriper

locking the timing is fine on your setup, helps...

locking the timing is fine on your setup, helps idle quality, idle circut is different in the new carbs, so both locked timing and new carbs helped, if you need help getting dialed in try calling...
09-11-2019, 02:42 PM
Replies: 3
Views: 537
Posted By ezstriper

I have had the chinese wire on trailers do the...

I have had the chinese wire on trailers do the exact same thing...total crap we are getting from that ****hole !!! must be some cheap tin crap tinted to look like copper !
09-11-2019, 02:38 PM
Replies: 4
Views: 502
Posted By ezstriper

Buy a aluminum trailer...

Buy a aluminum trailer...
08-12-2019, 03:53 PM
Replies: 7
Views: 706
Posted By ezstriper

just remember you are pulling on 3/8 bolt...

just remember you are pulling on 3/8 bolt...
Forum: General Q & A
07-18-2019, 08:05 AM
Replies: 8
Views: 651
Posted By ezstriper

I would say 2000psi lines with pressed on...

I would say 2000psi lines with pressed on fittings, ones I did used a local hyd hose co to make all of them up...not cheap but pump pressure can be well over 1000psi. I tried the Harden kit a while...
Forum: General Q & A
07-18-2019, 07:57 AM
Replies: 10
Views: 551
Posted By ezstriper

My son's AT we just installed the Daytona boxes...

My son's AT we just installed the Daytona boxes on, seem to work well, I had used their LS box on a carbed race car before and it worked well. I also tried playing with EST's seems they work well in...
Forum: General Q & A
07-17-2019, 07:12 AM
Replies: 4
Views: 244
Posted By ezstriper

I always ran them in the oil filter mount

I always ran them in the oil filter mount
Forum: General Q & A
07-17-2019, 07:06 AM
Replies: 10
Views: 551
Posted By ezstriper

well many run dist locked at 30+ so 26 at idle...

well many run dist locked at 30+ so 26 at idle will not cause a issue, EST also have about 20 deg in the marine ones, set the total around 32 and let the base fall wherever, sounds like you have...
Forum: General Q & A
07-04-2019, 08:32 AM
Replies: 22
Views: 735
Posted By ezstriper

Ok, not to jack this thread but my son's 32AT...

Ok, not to jack this thread but my son's 32AT doing the exact same thing. When he bought the boat was that way, found a B/S setup fitting on the pressure side of the pump, removed that and no change,...
Forum: Eliminator
06-11-2019, 07:27 AM
Replies: 2
Views: 2,038
Posted By ezstriper

I had a 81 Daytona V-drive, sold and now doing a...

I had a 81 Daytona V-drive, sold and now doing a 78 Daytona jet, they are great built boats, strong following and hold their value. they made many v hull jets and are popular today, also made I/O...
06-11-2019, 07:17 AM
Replies: 14
Views: 2,246
Posted By ezstriper

Had brothers I knew each bought gas ones, hated...

Had brothers I knew each bought gas ones, hated them, killed brakes quickly as had other issues as well, both dumped them pretty quick and lost big time..
06-11-2019, 07:13 AM
Replies: 2
Views: 696
Posted By ezstriper

need to look up specs on boat weight wise, if you...

need to look up specs on boat weight wise, if you look at it get a measurement from the bow eye to the transom, you will need these when looking for a trailer, I am a venture dealer and feel free to...
Forum: General Q & A
06-05-2019, 07:35 AM
Replies: 48
Views: 2,775
Posted By ezstriper

couple of things..as said wideband needed to see...

couple of things..as said wideband needed to see where you are...may be way to rich now due to carb signal. need to talk to cam people about your combo and find out where the H/P and torque are RPM...
Forum: General Q & A
06-05-2019, 07:20 AM
Replies: 465
Views: 39,568
Posted By ezstriper

good luck on your water test ! been messing with...

good luck on your water test ! been messing with LS stuff for long time, currant build twin turbo 6.0 in 19 eliminator Daytona jet. I have talked with others doing LS swaps and many have had revision...
Forum: General Q & A
04-22-2019, 07:34 AM
Replies: 1
Views: 190
Posted By ezstriper

P/S pumps

I know we been thru this before, but would not come up in search here, anybody remember the application for a Saginaw P/S pump that works with Hyd steering ? I have done this before but was several...
04-18-2019, 07:47 AM
Replies: 9
Views: 1,196
Posted By ezstriper

I think all the manufactures are in a towing...

I think all the manufactures are in a towing weight war, big losers are us..just because they say it will pull xxxxxlbs means only it may pull it. Like other said I would not even consider anything...
Forum: General Q & A
04-11-2019, 07:31 AM
Replies: 26
Views: 1,221
Posted By ezstriper

I would say 2hrs each [email protected] hour is going to...

I would say 2hrs each [email protected] hour is going to be what most places would charge
Forum: General Q & A
03-17-2019, 10:34 AM
Replies: 28
Views: 1,925
Posted By ezstriper

GM does not assemble the engines for marine...

GM does not assemble the engines for marine use...found out when found a scat crank in my new GM 454, so easily could have been assembled with felpro gaskets. Also what I have seen is terrible...
Forum: General Q & A
03-14-2019, 07:42 AM
Replies: 28
Views: 1,925
Posted By ezstriper

Does not look good, did a pair of engines few...

Does not look good, did a pair of engines few years back, ended up replacing 1 block and all 4 heads as they were eaten up beyond what I considered usable...
03-14-2019, 07:35 AM
Replies: 39
Views: 2,513
Posted By ezstriper

I'd say a matter of taste, I love sunroof's, if...

I'd say a matter of taste, I love sunroof's, if I'm looking a couple vehicles and one has a roof and one does not...leaning quickly to the one that does. I have had to many to count and never had a...
Forum: General Q & A
03-09-2019, 08:49 AM
Replies: 8
Views: 369
Posted By ezstriper

you have to be very careful on your choice, I did...

you have to be very careful on your choice, I did a setup like this few years ago, had a eddie marine HP arrester, 1st run would not make any boost 0 !! called weiand, said remove arrester 1st and...
Forum: General Q & A
02-28-2019, 08:39 AM
Replies: 465
Views: 39,568
Posted By ezstriper

Nice looking setup...not sure how the 102 mm TB...

Nice looking setup...not sure how the 102 mm TB going to be on a boat...may hurt the power where you need it most
Forum: General Q & A
02-28-2019, 08:36 AM
Replies: 4
Views: 381
Posted By ezstriper

running them to with no issues, friend has 2 in...

running them to with no issues, friend has 2 in cruiser I had him get, I used to use the cheap ones from Jegs/summit etc, and used to be fine...then they turn to junk failing left and right...chinese...
02-28-2019, 08:32 AM
Replies: 10
Views: 923
Posted By ezstriper

One issue is low tire pressure or tires...

One issue is low tire pressure or tires overloaded, see wear on inside as well as outside, the worse outside wear would have to be to much positive camber. A trailer axles are built with a arch in...
Showing results 1 to 25 of 500
 


 
Forum Jump

OSO Sponsor
OSO Advertiser
OSO Advertiser
OSO Advertiser
OSO Advertiser
OSO Advertiser

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

OSO Advertiser