Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: NHGuy
Showing results 1 to 25 of 25
Search took 0.06 seconds.
Forum: General Q & A
08-28-2021, 12:48 AM
Replies: 76
Views: 18,895
Posted By Reg119

Solved!

https://cimg4.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/750x1334/2b1d8234_12fb_42af_91d7_28e0a3addf0c_0bb72de02364b6b8af32348b1e8ca77bd3b2e348.jpeg
Well I timed the cam wrong. I just found it...
Forum: General Q & A
08-02-2021, 04:41 PM
Replies: 17
Views: 1,889
Posted By [email protected]

I was able to resolve this. I believe the key...

I was able to resolve this. I believe the key take away was that the Electronic Spark Timing on the distributor was not grounded properly to the distributor. Once grounded well I got spark. I also...
07-28-2021, 09:28 AM
Replies: 21
Views: 1,348
Posted By ThisIsLivin

The problem with most carbs out of the box is...

The problem with most carbs out of the box is they are designed for cars that have a multi gear transmission and can rev much quicker than in boats. In addition boats are under constant load. I...
07-19-2021, 09:36 PM
Replies: 0
Views: 1,028
Posted By Stuckonstupid

Check Your Fuel Tanks

Just a PSA, I know thereís a ton of ballers on here and a ton of ballers on a budget, this is just an FYI to pay attention to all of the inner workings of your boat, not just the motor and out drive....
Forum: General Q & A
07-19-2021, 02:06 PM
Replies: 22
Views: 796
Posted By SB

When line is to flame arrestor, it is a vent...

When line is to flame arrestor, it is a vent hose, not a vacuum line. When hooked to a vacuum nipple on tbi, it will become a vacuum hose and it will reduce psi when under vacuum. As throttle blades...
Forum: General Q & A
07-19-2021, 01:55 PM
Replies: 22
Views: 796
Posted By KennethF

UPDATE: Replaced Fuel Pressure regulator and...

UPDATE:
Replaced Fuel Pressure regulator and Fue pressure is always on 30psi , it only fluctuates about +/- 3 psi . Tested boat and it feels to operate much better. Will try with Full Load next...
Forum: General Q & A
07-13-2021, 01:12 PM
Replies: 3
Views: 240
Posted By Don163

Thank you for the reply. It is a Donzi 22 classic...

Thank you for the reply. It is a Donzi 22 classic that has never been in water, started on the hose a couple time a year to cycle the valves. I picked it up, finished rigging it, and going to use it...
Forum: General Q & A
06-24-2021, 10:54 PM
Replies: 4
Views: 273
Posted By SB

This photo is helpful. You can also click on it a...

This photo is helpful. You can also click on it a few times to make it bigger. :thumbs...
Forum: General Q & A
05-24-2021, 04:10 PM
Replies: 8
Views: 831
Posted By Baja Rooster

D.U.I. Distributers recommend.055 and most of us...

D.U.I. Distributers recommend.055 and most of us lost a good deal of top end with that. Pulled it back to .038 and all was good again. Iím no engine builder but just by crowd sourcing info from the...
05-23-2021, 09:32 AM
Replies: 10
Views: 1,787
Posted By Sonic30ss

Excalibur/Arneson update

Finally! After building swim platform extension, painting/ rigging transom and bilge, I got the Arneson's hung.
Looking forward to dropping fresh power in next week.


...
04-13-2021, 11:09 AM
Replies: 10
Views: 1,890
Posted By Baja Rooster

I use one of those only about 10-15 times each...

I use one of those only about 10-15 times each time I open the hatch. ;p
12-07-2020, 02:10 PM
Replies: 34
Views: 4,169
Posted By SB

OP - I swear this website used to bleed...

OP - I swear this website used to bleed performance.

Now itís Ďsell your boat snd buy something with an outboard, preferably a center console.Ē My have Times changed. Lololol
Forum: General Q & A
07-23-2020, 10:11 PM
Replies: 6
Views: 1,285
Posted By ICDEDPPL

So far the CompCams XD short travel have been a...

So far the CompCams XD short travel have been a winner in my boat

https://www.compcams.com/xd-short-travel-retro-fit-hydraulic-roller-lifter-set-for-chevrolet-big-block.html

Nice and quiet to...
Forum: General Q & A
01-01-2020, 11:55 AM
Replies: 20
Views: 1,778
Posted By Jzurs

Fixed. Figure led it out

Been a while since Iíve been back, new job has me working a lot and took most of the summer to gut my boat and replace transom, stringers , foam and floor, after I put the motor back in and started...
08-25-2019, 04:54 PM
Replies: 15
Views: 16,288
Posted By dunnitagain

My fool proof way is to pump it all out. Then...

My fool proof way is to pump it all out. Then fill it with cheap ass oil and a Pint or 2 of .... wait for it ... SEAFOAM then run it up to temp.
The alcohol in the seafoam will emulsify most of the...
07-30-2019, 04:31 PM
Replies: 21
Views: 3,567
Posted By F-2 Speedy

https://cimg0.ibsrv.net/gimg/www.offshoreonly.com-...

https://cimg0.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/2000x1504/20190225_160823_a306f06bc123c59ba4c0d479dddde228db177801.jpg
Im running two stage pumps -12 to the intercooler....-20 to the...
07-14-2019, 03:17 AM
Replies: 10
Views: 1,768
Posted By Griff

Punch a hole on the top center of the filter the...

Punch a hole on the top center of the filter the night before. All the oil will drain to the pan and you can just take off the filter and put in a plastic bag. Been doing it this way for years and...
Forum: General Q & A
06-26-2019, 09:47 AM
Replies: 132
Views: 26,283
Posted By Paxtonspeed

Update on the boat. I threw on a 19 pitch...

Update on the boat. I threw on a 19 pitch stainless prop, the boat runs better. RPM's came up to 5000 at 60 MPH. Last time I had it out, we had 8 people on it, 4 of which were kids, 42 gallons of...
Forum: General Q & A
03-25-2019, 09:01 PM
Replies: 12
Views: 2,089
Posted By Cap'm Kurt

Like he said, just run it and check it. Be...

Like he said, just run it and check it. Be easier to pull plugs first and look for moisture. I've got stock 502 mpi mag with only Eddie Marine exhaust and have had severe reversion since day one. ...
Forum: General Q & A
10-17-2018, 01:49 PM
Replies: 3
Views: 282
Posted By Griff

What kind of stupid idiot comes to a website and...

What kind of stupid idiot comes to a website and then calls the people who control the parameters of the site stupid idiots.
You are correct............Some people are just brain dead in this world!!
Forum: General Q & A
08-06-2018, 07:27 PM
Replies: 15
Views: 2,128
Posted By articfriends

https://cimg9.ibsrv.net/gimg/www.offshoreonly.com-...

https://cimg9.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/2000x1124/20180806_111759_be2f4b79c737916a4a5e2a698b168e4e5f9469f7.jpg
52 tooth/7.5lbs boost
Forum: General Q & A
10-12-2017, 06:02 PM
Replies: 23
Views: 4,960
Posted By 94sylvan

Thought I would update this thread. I still...

Thought I would update this thread. I still haven't pulled the engine to reset the cam to straight up, but have made several other improvements. First, we rechecked timing and we were only at 32...
10-09-2017, 01:46 PM
Replies: 57
Views: 16,182
Posted By ramos45

Built mine out of wood and galvanized hardware...

Built mine out of wood and galvanized hardware and used a chain hoist from HF. I have the detailed plans at home, let me know and I'll snap a pic for you. In total it's about 14ft tall. I've used it...
07-18-2017, 01:06 PM
Replies: 1
Views: 417
Posted By LT1GMC

Awesome service shout-out

I want to thank a longtime Offshore member and contributor for some excellent service this last week. Steve Smith, aka Smitty or Articfriends, came to our rescue. We were trying to get our project...
Forum: Formula
04-18-2012, 06:39 PM
Replies: 6
Views: 2,631
Posted By aquaforce

Here is a copy of a post I made on this topic on...

Here is a copy of a post I made on this topic on another site. If this doesn't answer all your questions just ask.

It is just time consuming and you need extra hands but not too bad for a diy job....
Showing results 1 to 25 of 25


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.