Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: bolin22
Showing results 1 to 25 of 48
Search took 0.01 seconds.
07-13-2022, 02:14 PM
Replies: 227
Views: 35,110
Posted By bolin22

10 Days away! Does anyone know where the stops...

10 Days away! Does anyone know where the stops will be this year? Still running to Bayview?
Forum: General Q & A
05-27-2022, 11:21 AM
Replies: 32
Views: 1,087
Posted By bolin22

Thanks for that info on the IAT. I pulled the...

Thanks for that info on the IAT.
I pulled the linkage off at the TB and watched the scan tool while manually opening the throttle blades. TPS voltage at idle was .54V and started increasing...
Forum: General Q & A
05-25-2022, 03:20 PM
Replies: 32
Views: 1,087
Posted By bolin22

Yes, it def has an IAT in the flame arrestor. ...

Yes, it def has an IAT in the flame arrestor.
The weird part is the scanner is reading Manifold Air Temp....
Forum: General Q & A
05-25-2022, 01:35 PM
Replies: 32
Views: 1,087
Posted By bolin22

yes it idles around 750-800.

yes it idles around 750-800.
Forum: General Q & A
05-25-2022, 01:35 PM
Replies: 32
Views: 1,087
Posted By bolin22

Yes the scanner reads both. I will try and get a...

Yes the scanner reads both. I will try and get a video of the linkage moving while reading voltage and %.
I do have the service manual but not the "Diag" supplement. I looked through the manual and...
Forum: General Q & A
05-25-2022, 01:17 PM
Replies: 32
Views: 1,087
Posted By bolin22

I believe it is, the throttle blades start moving...

I believe it is, the throttle blades start moving and the motor RPM raises from idle to around 1100 (like in the first video). Is there an adjustment procedure for the cable that I can verify?
Forum: General Q & A
05-25-2022, 12:59 PM
Replies: 32
Views: 1,087
Posted By bolin22

I took this video last night while watching the...

I took this video last night while watching the TPS % on the scan tool. The throttle lever moves quite a bit before the TPS is picking up %. It seems the approximate location where the tps starts to...
Forum: General Q & A
05-25-2022, 12:53 PM
Replies: 32
Views: 1,087
Posted By bolin22

also the first time I pulled the codes there was...

also the first time I pulled the codes there was a code 21 TPS voltage high, code 23 MAT sensor voltage high, and code 34 map sensor voltage low....as stated I have replaced the TPS and MAP but have...
Forum: General Q & A
05-25-2022, 12:48 PM
Replies: 32
Views: 1,087
Posted By bolin22

Just thought of something else that seems...

Just thought of something else that seems strange, when I am scrolling through the scan tool there is a MAT sensor reading (last night it was reading -34 deg F) but i do not think the 575 has a MAT...
Forum: General Q & A
05-25-2022, 12:27 PM
Replies: 32
Views: 1,087
Posted By bolin22

IF I just smash through that spot it does not...

IF I just smash through that spot it does not stall. Not ideal as I was always taught to take off easy to help protect the drive. I am more concerned with maneuvering and needing to throttle up a bit...
Forum: General Q & A
05-25-2022, 11:44 AM
Replies: 32
Views: 1,087
Posted By bolin22

fuel pressure on the dash gauge seems fine, same...

fuel pressure on the dash gauge seems fine, same as before the plate but I did need to install a fitting to adapt the sensor to the plate. I have not hooked a gauge in-line. I will look over the...
Forum: General Q & A
05-25-2022, 11:27 AM
Replies: 32
Views: 1,087
Posted By bolin22

possibly, I am not going to rule out anything,...

possibly, I am not going to rule out anything, not sure how to check that.
Forum: General Q & A
05-25-2022, 10:31 AM
Replies: 32
Views: 1,087
Posted By bolin22

I checked the timing at idle, but I can check it...

I checked the timing at idle, but I can check it again. Running Eddies' tune for his plate for a stock engine. The lean cough started after installing his plate. Eddie is saying its the same tune he...
Forum: General Q & A
05-25-2022, 10:00 AM
Replies: 32
Views: 1,087
Posted By bolin22

Yes, I have put a new cap and rotor on several...

Yes, I have put a new cap and rotor on several times, plugs every 20 hours, replaced the module underneath the cap, wires are about 100 hours, however, I will inspect....again. Not ruling out...
Forum: General Q & A
05-24-2022, 01:44 PM
Replies: 32
Views: 1,087
Posted By bolin22

Yes, I replaced the IAC with a factory Merc...

Yes, I replaced the IAC with a factory Merc before I did the Eddie Young upgrade. I believe the original was working as there was no change from old to new.
Forum: General Q & A
05-24-2022, 01:21 PM
Replies: 32
Views: 1,087
Posted By bolin22

here is a video of the issue (hopefully the link...

here is a video of the issue (hopefully the link works for you).
https://www.icloud.com/photos/#043X8Zj2wJi1tp1dsiVXBrRHA
Forum: General Q & A
05-24-2022, 01:14 PM
Replies: 32
Views: 1,087
Posted By bolin22

I developed an issue last season with startup....

I developed an issue last season with startup. cold/hot, didn't matter, when starting it would crank over, a few cylinders would fire, then just crank crank crank.....until i raised the throttle...
Forum: General Q & A
05-24-2022, 11:58 AM
Replies: 32
Views: 1,087
Posted By bolin22

575sci issues

Who is the resident 575 expert on here? I have a 2002 29 Fever/575 that I am having trouble figuring out some issues.
04-27-2022, 09:28 PM
Replies: 227
Views: 35,110
Posted By bolin22

I am excited to hear the 2nd annual run is a go....

I am excited to hear the 2nd annual run is a go. I am looking for a slip to stay in for the weekend if anyone has any leads. Thx
Forum: Fountain
08-30-2021, 04:43 PM
Replies: 1
Views: 374
Posted By bolin22

there was a thread over on the Fountain powerboat...

there was a thread over on the Fountain powerboat owners facebook page about a guy(Bill Wiles) replacing the icechest with an ICECO GO20 in his 38....I think the icebox dimensions are very similar....
08-18-2021, 09:48 AM
Replies: 6
Views: 909
Posted By bolin22

Updated gaskets were installed before I bought...

Updated gaskets were installed before I bought the boat, I plan on replacing this winter again. I dont have access to a scanner at the moment, will try an IAC and see if that helps, sounds like those...
08-16-2021, 02:18 PM
Replies: 6
Views: 909
Posted By bolin22

I did a leakdown over the winter and everything...

I did a leakdown over the winter and everything looked good then. I did a compression test last weekend and all were within 5psi of each other. The weird part is I put a mech fuel pump in it as there...
08-16-2021, 12:08 PM
Replies: 6
Views: 909
Posted By bolin22

575SCi backfire through exhaust

I have a 2002 29 Fever with a 575/XR. I have an issue with the motor starting, particularly when cold, but sometimes will do it when warm as well but not all the time. Motor will fire for a split...
07-26-2021, 04:57 PM
Replies: 227
Views: 35,110
Posted By bolin22

https://cimg5.ibsrv.net/gimg/www.offshoreonly.com-...

https://cimg5.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/2000x1333/img_4769_b34592e620bcf141cc9fb83d9ed19e38ebcbd379.jpg
07-20-2021, 01:53 PM
Replies: 227
Views: 35,110
Posted By bolin22

awesome thanks for the info, we have parking for...

awesome thanks for the info, we have parking for the trailer at the VRBO. Is there a launch fee?
Showing results 1 to 25 of 48
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.