Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: troyc565
Showing results 1 to 14 of 14
Search took 0.00 seconds.
Forum: General Q & A
09-14-2021, 10:00 AM
Replies: 11
Views: 537
Posted By troyc565

Thanks. I am replacing the intake with a better...

Thanks. I am replacing the intake with a better flowing setup.
Forum: General Q & A
09-13-2021, 03:11 PM
Replies: 11
Views: 537
Posted By troyc565

525 efi stock fuel system capabilities

525 efi stock fuel system. How much hp can the stock pumps and injectors support?
Forum: LaveyCraft
02-09-2020, 06:55 PM
Replies: 1
Views: 1,011
Posted By troyc565

GPS transducer for steeped hull

I have a 2004 29 NuEra 525 efi and the depth finder does not work at any speed past idle. I am installing a Garmin 94sv plus and I am wondering if I will be able to use it while on plane and which...
Forum: Swap Shop
07-01-2018, 07:45 PM
Replies: 22
Views: 3,540
Posted By troyc565

is the sea strainer 1 1/4 inch in and outlet

is the sea strainer 1 1/4 inch in and outlet
11-12-2012, 06:11 PM
Replies: 4
Views: 1,004
Posted By troyc565

does 502 have guardian mode

i have 1997 502 mpi 24 foot baha. does it have guardian mode. if it does, can you clear guardian mode by using led at diagnostic connector & moving throttle. i dont have a clear understanding of...
Forum: General Q & A
11-06-2012, 04:47 PM
Replies: 2
Views: 500
Posted By troyc565

i found out that code 15 is for the intake air...

i found out that code 15 is for the intake air temp sensor, i pulled it out & tested it, it is bad. thanks
Forum: General Q & A
11-05-2012, 05:23 PM
Replies: 2
Views: 500
Posted By troyc565

whipple fault code 15

i cant find a code description for a 502 mpi with a whipple on it. the light for whipple flashes a code 15. i tried whipple & have not heard back from them yet. thanks for help
07-03-2012, 06:15 PM
Replies: 2
Views: 626
Posted By troyc565

thank you jaytee

thank you jaytee
07-03-2012, 12:03 AM
Replies: 2
Views: 626
Posted By troyc565

bravo 1 spanner wrench length

i am attempting to make my own spanner wrench for the pinion housing retainer nut & need to know the length from center of spanner nut to center of where torque wrench fits. i think the length will...
Forum: General Q & A
01-31-2008, 09:59 PM
Replies: 3
Views: 2,158
Posted By troyc565

i ran a moroso cool can on my drag car with a...

i ran a moroso cool can on my drag car with a carb & it did help keep the fuel pressure stable on very hot days.
Forum: General Q & A
01-31-2008, 09:56 PM
Replies: 8
Views: 1,922
Posted By troyc565

how do you think the fuel consumption would be at...

how do you think the fuel consumption would be at cruising speed with the 565 compared to the 454.
Forum: General Q & A
01-30-2008, 02:13 PM
Replies: 8
Views: 1,922
Posted By troyc565

here is more info on the heads the brodix heads...

here is more info on the heads
the brodix heads are 312cc intake runners out of the box. they have been ported for drag racing for high rpms.
the iron heads are gm heads, part # 12562920, they...
Forum: General Q & A
01-29-2008, 10:56 PM
Replies: 8
Views: 1,922
Posted By troyc565

i am afraid the brodix heads will make the boat...

i am afraid the brodix heads will make the boat slugish at low rpms also. i wonder if the 565 will use alot more fuel at cruise speed or will it be close to the same as the 454.
Forum: General Q & A
01-29-2008, 09:15 PM
Replies: 8
Views: 1,922
Posted By troyc565

head selection for 565

i am impressed with the amount of knowledge on this board & could use a little advice. i have a 24 foot vip vindicator with a mild 454 & 750 holley & bravo 1 that runs 60 mph with gps. i want to swap...
Showing results 1 to 14 of 14


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.