Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: camptappakeg69
Showing results 1 to 25 of 500
Search took 0.06 seconds.
08-08-2020, 08:23 PM
Replies: 28
Views: 3,982
Posted By camptappakeg69

Congrats! Beautiful boat!

Congrats! Beautiful boat!
Forum: General Q & A
08-08-2020, 06:31 PM
Replies: 61
Views: 8,143
Posted By camptappakeg69

Fought with fuel problems with my mefi 1 502mag...

Fought with fuel problems with my mefi 1 502mag for.many years, although I had the much worse vst system, I finally cured it by taking all out and installing an aeromotive pump and regulator, I have...
Forum: General Q & A
05-17-2020, 07:28 PM
Replies: 87
Views: 13,198
Posted By camptappakeg69

Mine sounds like that, it is the internal exhiast...

Mine sounds like that, it is the internal exhiast flappers clacking on mine.
06-09-2019, 04:19 PM
Replies: 9
Views: 1,764
Posted By camptappakeg69

Governor Cuomo just demanded action...so the...

Governor Cuomo just demanded action...so the water will drop immediately....
Forum: General Q & A
06-03-2019, 05:26 PM
Replies: 110
Views: 20,456
Posted By camptappakeg69

Small filter on the pressure regulator clogged?...

Small filter on the pressure regulator clogged? Anti-siphon valve on tank?
Forum: General Q & A
05-31-2019, 04:48 PM
Replies: 110
Views: 20,456
Posted By camptappakeg69

On my 502 there is a yellow vent tube that lead...

On my 502 there is a yellow vent tube that lead down to the mech fuel pump, my understanding was this was only in case the mechinal pump diaphragm failed it would send fuel to the vst instead of...
Forum: General Q & A
05-29-2019, 05:17 PM
Replies: 110
Views: 20,456
Posted By camptappakeg69

Have you tried running it on a separate gas...

Have you tried running it on a separate gas container to rule out a supply/ tank issue, does it have separate fuel tanks for each motor? Your other motor is running good if i remember.
Forum: General Q & A
05-27-2019, 08:52 PM
Replies: 110
Views: 20,456
Posted By camptappakeg69

Just remembered another issue on my engine, more...

Just remembered another issue on my engine, more of an intermittent no start. I checked all the wires running into the ecm/relay metal box on the top of engine, a couple of them had rubbed through...
Forum: General Q & A
05-17-2019, 09:16 AM
Replies: 37
Views: 31,902
Posted By camptappakeg69

Sounds like my old symptoms, fuel issue, vst...

Sounds like my old symptoms, fuel issue, vst probably, check the high pressure side while under load with a gauge,engine might be starving for fuel
Forum: General Q & A
04-27-2019, 09:11 AM
Replies: 110
Views: 20,456
Posted By camptappakeg69

I agree with Bup too, I had the injectors cleaned...

I agree with Bup too, I had the injectors cleaned and checked about 20 hrs ago, when I still was hopefull that one of my VST rebuilds would work. It seemed to help and ran strong.
Remembering a...
Forum: General Q & A
04-24-2019, 07:01 PM
Replies: 110
Views: 20,456
Posted By camptappakeg69

It was dumping all that extra fuel into the...

It was dumping all that extra fuel into the plenum, would run great above 1500 or so but would idle like crap.... ended up plugging the port after removing the vst...
Forum: General Q & A
04-24-2019, 06:50 PM
Replies: 110
Views: 20,456
Posted By camptappakeg69

I had numerous issues that seem like yours, most...

I had numerous issues that seem like yours, most all came back to the vst. Poor idle, surging, black soot, raw fuel coming out exhaust. Rebuilt vst numerous times, clogged screen in the bottom of it,...
04-07-2019, 07:32 PM
Replies: 15
Views: 2,576
Posted By camptappakeg69

Yes the merc filter /separator, which i think was...

Yes the merc filter /separator, which i think was a 40 micron, is before the pump then the 10 micron is before the rail/injectors
04-07-2019, 06:57 PM
Replies: 15
Views: 2,576
Posted By camptappakeg69

Close,I removed the mechanical pump on the...

Close,I removed the mechanical pump on the seawater pump, relocated the fuel filter block to the front bulkhead, Aeromotive pump mounted low in the bilge pulls fuel through it,fuel enters 10micron...
04-06-2019, 08:33 PM
Replies: 15
Views: 2,576
Posted By camptappakeg69

If I remember correctly the bottom rail was the...

If I remember correctly the bottom rail was the factory return, no need to plug as it isn't used once the factory regulator has been removed and the rail end was cut off. I ended up returning the...
04-06-2019, 08:19 PM
Replies: 15
Views: 2,576
Posted By camptappakeg69

https://cimg3.ibsrv.net/gimg/www.offshoreonly.com-...

https://cimg3.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/1030x579/20160608_203051_1f71247e427f6c71810f33be53af038dbbd4167b.jpg...
04-06-2019, 08:06 PM
Replies: 15
Views: 2,576
Posted By camptappakeg69

Was pretty simple to mod the fuel rail, I cut the...

Was pretty simple to mod the fuel rail, I cut the factory regulator and the end of the rail off, drilled and tapped both ends, fuel enters from the rear then exits out the front to aeromotive...
12-07-2018, 09:22 PM
Replies: 45
Views: 8,787
Posted By camptappakeg69

Yes it...

Yes it does....https://cimg9.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/1080x1920/screenshot_2018_12_07_22_14_30_3cc1ae62531adebc2dec78086072384c82a27c10.png
Forum: General Q & A
10-21-2018, 09:06 PM
Replies: 5
Views: 510
Posted By camptappakeg69

I run the merc separator before the aeromotive...

I run the merc separator before the aeromotive 750 pump then the 10micron before the rail. No problems yet.
08-05-2018, 09:06 PM
Replies: 201
Views: 72,072
Posted By camptappakeg69

Dam, it's august...

Dam, it's august already!https://cimg1.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/720x960/fb_img_1531181193753_7891dc81a7857a674d1ac98d0adcf8d373307713.jpg
Forum: General Q & A
05-04-2018, 12:21 PM
Replies: 11
Views: 1,516
Posted By camptappakeg69

my stock filter /water-separator is before the...

my stock filter /water-separator is before the pump, the 10 micron filter is before the rail that I modified. Cut off stock regulator /filter end, drilled out and tapped both ends for AN fittings....
Forum: General Q & A
05-03-2018, 12:14 PM
Replies: 11
Views: 1,516
Posted By camptappakeg69

I put my aeromotive low as possible in the bilge...

I put my aeromotive low as possible in the bilge after the merc filter/separator, then the 10 micron in line filter just before it enters the fuel rail. Was told them pumps like to push fuel ,not...
02-27-2018, 08:31 PM
Replies: 25
Views: 3,667
Posted By camptappakeg69

https://cimg1.ibsrv.net/gimg/www.offshoreonly.com-...

https://cimg1.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/2000x1124/20170827_141923_0484d54e9f10242c5dbfbedd11e09e9f76683cf8.jpg
Only had it on the lake once this summer, hopefully will make up...
02-27-2018, 08:19 PM
Replies: 41
Views: 2,224
Posted By camptappakeg69

So sorry for your loss

So sorry for your loss
11-30-2017, 06:32 PM
Replies: 43
Views: 10,957
Posted By camptappakeg69

Looks great! Good luck with it!

Looks great! Good luck with it!
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.