Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: ACrooks69
Showing results 1 to 25 of 405
Search took 0.07 seconds.
Forum: General Q & A
06-17-2019, 01:14 PM
Replies: 15
Views: 512
Posted By ACrooks69

Also, I know I can go R5671A-8 (assuming that...

Also, I know I can go R5671A-8 (assuming that would be 1 colder than what I currently have) , but I was hoping for a resistor plug. I did run FR5 in a prior application so it should be fine. I wasn't...
Forum: General Q & A
06-17-2019, 07:32 AM
Replies: 15
Views: 512
Posted By ACrooks69

414ci 623hp corr on dyno, figure 580ish corrected...

414ci 623hp corr on dyno, figure 580ish corrected through the manifolds.
Forum: General Q & A
06-17-2019, 07:01 AM
Replies: 15
Views: 512
Posted By ACrooks69

Can you suggest a non projected tip 8 heat range...

Can you suggest a non projected tip 8 heat range plug? I had been looking in the NGK catalog, but don't think they make one. Maybe in another manufacturer?
Forum: General Q & A
06-16-2019, 11:36 PM
Replies: 15
Views: 512
Posted By ACrooks69

It's a NGK BKR7E, had 3924 come apart after 2...

It's a NGK BKR7E, had 3924 come apart after 2 seasons. Had some deto in midrange and wasn't fuel control or timing related. Added fuel and pulled timing and didn't seem to do much. The next week...
Forum: General Q & A
06-16-2019, 02:52 PM
Replies: 15
Views: 512
Posted By ACrooks69

That's weird with the pics. Here are the full...

That's weird with the pics. Here are the full size.
CI, I know the right way to do it. I just pulled the m to check and they looked unusual. I guess I would expect the porcelain to clean itself off...
Forum: General Q & A
06-16-2019, 12:01 PM
Replies: 15
Views: 512
Posted By ACrooks69

Read my plugs

So I pulled my plugs out today just to take a look and the picture is what I found. The other bank is pretty similar. Procharger 6psi, Accel DFI, wideband, o2 13.1-13.4 cruise, 12-12.7 from 3200 to...
Forum: Wanted
05-13-2019, 09:44 AM
Replies: 14
Views: 822
Posted By ACrooks69

It is a stock mercury modified B1. Only Merc...

It is a stock mercury modified B1. Only Merc modified it from the standard B1 to the XS, and yes a RH. The blades are thinned from the factory over a std B1. Has vent holes. Great hole shot on my 23...
Forum: Wanted
05-11-2019, 11:10 AM
Replies: 14
Views: 822
Posted By ACrooks69

I have a 24 B1 XS in mint condition. $400...

I have a 24 B1 XS in mint condition. $400 shipped, US. What boat are you going to run it on?
Forum: Swap Shop
05-07-2019, 09:09 PM
Replies: 15
Views: 2,296
Posted By ACrooks69

It is a standard Alpha gimbel not a Gen 2, but I...

It is a standard Alpha gimbel not a Gen 2, but I made my gen 2 gimbel work with the SS.
Forum: Swap Shop
05-04-2019, 11:42 AM
Replies: 15
Views: 2,296
Posted By ACrooks69

I believe is was part of the 320EFI and the 300...

I believe is was part of the 320EFI and the 300 Tempest package from 86-88. I picked up about 5mph as well with my 430hp 185 searay. 75 GPS. After I sold mine, the guy put it behind 520hp and snapped...
Forum: General Q & A
03-20-2019, 05:33 PM
Replies: 16
Views: 598
Posted By ACrooks69

Check your plug wires. I had issues with my oil...

Check your plug wires. I had issues with my oil pressure gauge jumping around over 3500rpm, turns out my coil wire was laying on the sending unit. Check wire harness crossover point to plug wires.
Forum: General Q & A
02-11-2019, 02:14 PM
Replies: 56
Views: 4,200
Posted By ACrooks69

are you taking about the CMIs or Lightnings with...

are you taking about the CMIs or Lightnings with that reference?
Forum: General Q & A
01-14-2019, 11:27 AM
Replies: 56
Views: 4,200
Posted By ACrooks69

Well, I know the guy who designed the TnL headers...

Well, I know the guy who designed the TnL headers and he did make them for bigger motors. As analytical as that guy is, if he put any effort into them, he did them right, not blingy. I mean he's only...
01-05-2019, 08:29 PM
Replies: 6
Views: 592
Posted By ACrooks69

+1 on the redline shockproof and my dad's boat. ...

+1 on the redline shockproof and my dad's boat. Makes sense either way.
Forum: General Q & A
12-21-2018, 09:20 PM
Replies: 12
Views: 1,227
Posted By ACrooks69

I have a SHP 4.125x3.875 (414). Cam spec similar...

I have a SHP 4.125x3.875 (414). Cam spec similar to your second. [email protected] with 8.4:1 comp, 615 with 6lbs boost.
11-10-2018, 10:56 PM
Replies: 10
Views: 993
Posted By ACrooks69

Time to take a look at the J-R Marine gimble ring...

Time to take a look at the J-R Marine gimble ring repair.
09-21-2018, 11:20 AM
Replies: 47
Views: 3,711
Posted By ACrooks69

:drool1: Drive Porn!

:drool1: Drive Porn!
Forum: General Q & A
09-21-2018, 11:16 AM
Replies: 7
Views: 519
Posted By ACrooks69

The PCV isn't working very well at WOT because...

The PCV isn't working very well at WOT because there is almost no vacuum to assist pulling out excessive crankcase pressure. I had a similar issue and rigged up a crankcase evac system, but I...
09-15-2018, 11:13 PM
Replies: 98
Views: 4,833
Posted By ACrooks69

What kind of condition is the cap in? Is it...

What kind of condition is the cap in? Is it possible you are getting tracking from the terminals?
09-11-2018, 07:11 AM
Replies: 47
Views: 3,711
Posted By ACrooks69

Sorry, I meant could you turn the engine over...

Sorry, I meant could you turn the engine over when the shaft was still in?
Forum: General Q & A
09-11-2018, 07:03 AM
Replies: 18
Views: 917
Posted By ACrooks69

#1 was going to be my guess. Classic still...

#1 was going to be my guess. Classic still running with fuel screws all the way in.
09-11-2018, 06:59 AM
Replies: 47
Views: 3,711
Posted By ACrooks69

Wow, you twisted on both ends. I forget, was the...

Wow, you twisted on both ends. I forget, was the motor free to spin or locked up?
09-08-2018, 12:40 PM
Replies: 47
Views: 3,711
Posted By ACrooks69

:eek:You're going to need a bigger slide hammer!...

:eek:You're going to need a bigger slide hammer! Those splines are impressive.
Forum: Swap Shop
09-06-2018, 08:40 AM
Replies: 32
Views: 3,656
Posted By ACrooks69

Can you PM me the pics of the water dumps?

Can you PM me the pics of the water dumps?
09-06-2018, 08:38 AM
Replies: 98
Views: 4,833
Posted By ACrooks69

I just looked through the instructions and have a...

I just looked through the instructions and have a better idea on its capabilities. I don't like the 22 degree control limit, and see how that could be causing problems here. Is it 22 at max or can...
Showing results 1 to 25 of 405
 


 
Forum Jump

OSO Sponsor
OSO Advertiser
OSO Advertiser
OSO Advertiser
OSO Advertiser
OSO Advertiser
OSO Advertiser