Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: AllDodge
Showing results 1 to 25 of 500
Search took 0.08 seconds.
Forum: General Q & A
Today, 03:49 PM
Replies: 8
Views: 129
Posted By AllDodge

Being a 2017 means it has CAT's. Don't see that...

Being a 2017 means it has CAT's. Don't see that motor having a oil temp sensor and the -47 means its not connected.

There is something else causing it to go in limp mode. Need to get it scanned...
Forum: General Q & A
Today, 06:58 AM
Replies: 8
Views: 129
Posted By AllDodge

Would need to understand the problem, but if its...

Would need to understand the problem, but if its a MPI then the oil pressure sensor doesn't have anything to do with fuel pressure, if that's the issue
Forum: General Q & A
Yesterday, 06:17 PM
Replies: 8
Views: 129
Posted By AllDodge

Always best to give motor serial number when...

Always best to give motor serial number when asking questions

There are 2 places for senders or switches to be attached. Above the oil filter on the block, and below the distributor on the blocks...
Forum: Baja
08-07-2022, 06:59 PM
Replies: 5
Views: 118
Posted By AllDodge

A B3 is an easy swap, just change the lower. ...

A B3 is an easy swap, just change the lower. Props cost more (because x2) and they bite really well. There more efficient band the also weight a bit more. Your old drive and prop are about equal...
08-06-2022, 11:48 AM
Replies: 17
Views: 688
Posted By AllDodge

Did you find out if the angle changes by rotating...

Did you find out if the angle changes by rotating the crank 90* ?
Forum: General Q & A
08-05-2022, 06:59 AM
Replies: 24
Views: 796
Posted By AllDodge

If your gauge is accurate then 190 is to high. ...

If your gauge is accurate then 190 is to high.
Loosing power I'm thinking one injector is going lean. Be nice if you had a go-pro or mount the phone above the TB and watch
08-02-2022, 03:43 PM
Replies: 5
Views: 705
Posted By AllDodge

Probably need the antenna as mentioned Buddy...

Probably need the antenna as mentioned
Buddy has a 08 pickup with Nav, and the maps needed updating. Bought the update thru Chrysler (USB stick) and soon as it was plugged in, a Y/N question came...
Forum: General Q & A
08-01-2022, 07:25 AM
Replies: 20
Views: 656
Posted By AllDodge

A used motor looking good or bad some things...

A used motor looking good or bad some things should be looked at before even firing it up. Thermostat is one of them

That said, its so rusty, use a mechanical gauge as SB suggested. The motor is...
Forum: General Q & A
07-31-2022, 12:36 PM
Replies: 24
Views: 596
Posted By AllDodge

I would never buy injectors from ebay, amazon...

I would never buy injectors from ebay, amazon other kind of sellers, 100% or not. Never found anyone which can actually rebuild any injector other then older diesel mechanical type. If they pass...
Forum: General Q & A
07-31-2022, 08:24 AM
Replies: 30
Views: 681
Posted By AllDodge

Did you get the intake back ON, and if so what...

Did you get the intake back ON, and if so what are the voltages with motor running
07-30-2022, 04:24 PM
Replies: 30
Views: 1,954
Posted By AllDodge

Have not read the hole thread just glanced at...

Have not read the hole thread just glanced at this comment
Had a chain saw company in Louisville which had 2 rates. When we get time and express service. I didn't need my saw for a couple months...
Forum: General Q & A
07-26-2022, 09:14 AM
Replies: 4
Views: 228
Posted By AllDodge

Getting much over 150 I would expect a defective...

Getting much over 150 I would expect a defective gauge unless motor is rebuilt and compression has been increased. Either way sounds good because they are all within the same number

Could be the...
Forum: General Q & A
07-26-2022, 07:51 AM
Replies: 4
Views: 228
Posted By AllDodge

Can reflash the ECM using MEFI Burn software. ...

Can reflash the ECM using MEFI Burn software. Can the fuel tables and about anything you want. The issue is if your MEFI 3 is password protected, most are. So if you can find the Bin file for your...
07-24-2022, 08:53 AM
Replies: 15
Views: 408
Posted By AllDodge

Don't see it overcoming the valve. The pressure...

Don't see it overcoming the valve. The pressure will reduce back into the filter but keep in mind were talking a liquid (hydraulics). Pressure can be high, but even the slightest reduction in...
07-24-2022, 07:41 AM
Replies: 15
Views: 408
Posted By AllDodge

The antisphon valve is a one way only valve. It...

The antisphon valve is a one way only valve. It lets folw go toward the filter only. If things get heat soaked the fuel and any air expands, pressure builds
Forum: General Q & A
07-22-2022, 09:24 PM
Replies: 1
Views: 139
Posted By AllDodge

Agree you blew a fuse, find the fuse panel and...

Agree you blew a fuse, find the fuse panel and check the fuses
There is a 20 amp and 110 amp fuse on the trim pump
07-22-2022, 08:02 PM
Replies: 7
Views: 266
Posted By AllDodge

Looks like it GM part number12575055 at GM parts...

Looks like it GM part number12575055 at GM parts directhttps://www.ebay.com/itm/164615713003
Forum: General Q & A
07-22-2022, 10:41 AM
Replies: 30
Views: 681
Posted By AllDodge

4.99 is good enough Circuit 423 should key ON =...

4.99 is good enough
Circuit 423 should key ON = no more then 0.5V motor running = 1.2V
Circuit 424 should key ON = no more then 0.5V motor running = 4.5V

Did you get the module from GM or Merc?
07-22-2022, 10:17 AM
Replies: 15
Views: 408
Posted By AllDodge

Did you verify when it won't start by opening the...

Did you verify when it won't start by opening the gas cap and listen for air being sucked in?

Are you using type USCG type A1 fuel line, and not just lines from local NAPA?
07-22-2022, 09:51 AM
Replies: 15
Views: 408
Posted By AllDodge

Not the pump it is sucking the filter dry

Not the pump it is sucking the filter dry
Forum: General Q & A
07-22-2022, 09:44 AM
Replies: 30
Views: 681
Posted By AllDodge

delete wrong post

delete wrong post
07-22-2022, 09:36 AM
Replies: 15
Views: 408
Posted By AllDodge

Its VL but not being caused by sitting with...

Its VL but not being caused by sitting with current problem so much because the fuel filters go empty

Its either the antisiphon valve, fuel line pickup, weak pump, collapsing fuel line, fuel tank...
Forum: General Q & A
07-22-2022, 09:31 AM
Replies: 30
Views: 681
Posted By AllDodge

Without 5V there, then the EST is not...

Without 5V there, then the EST is not transferring timing to the ECM

When you say you have 5V on the others, is it exactly 5V or close to?
Forum: General Q & A
07-22-2022, 08:09 AM
Forum: General Q & A
07-22-2022, 07:59 AM
Replies: 30
Views: 681
Posted By AllDodge

It has EST ignition Are you getting 5V on pin...

It has EST ignition
Are you getting 5V on pin J2-24 Bypass?
Is there 5V reference at the MAP pin C and at TPS pin C?

...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.