Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: drumerjb
Showing results 1 to 25 of 113
Search took 0.01 seconds.
Forum: Electronics
10-03-2019, 09:16 PM
Replies: 3
Views: 891
Posted By drumerjb

Can't answer the volt range question. But I can...

Can't answer the volt range question. But I can help with the potentiometer test. Disconnect and do a sweep test on the 10000 ohms scale. This needs to be done with an analog meter. Watch the needle...
Forum: General Q & A
09-18-2019, 08:57 PM
Replies: 2
Views: 231
Posted By drumerjb

It would be very wise to remove the internal bar...

It would be very wise to remove the internal bar if you have external steering with a external link.
09-10-2019, 11:32 PM
Replies: 4
Views: 1,076
Posted By drumerjb

Any advice on repairing small nicks, dings and...

Any advice on repairing small nicks, dings and scratches in the clear coat?
09-08-2019, 10:37 PM
Replies: 4
Views: 1,076
Posted By drumerjb

It be nice if someone would respond to this post...

It be nice if someone would respond to this post I have the same exact interest or should I say problem.
Forum: Formula
08-19-2019, 06:25 PM
Replies: 25
Views: 1,794
Posted By drumerjb

I I have a 2011 GMC 3/4 ton pickup with a Duramax...

I I have a 2011 GMC 3/4 ton pickup with a Duramax in it. It was a huge improvement from my 2002 3/4 ton GMC with the 6.0. Not only performance-wise but towing wise. The new body style with the new...
Forum: Formula
08-18-2019, 11:00 PM
Replies: 25
Views: 1,794
Posted By drumerjb

I don't know my 6.0 or was it a 6.2 in my 2000...

I don't know my 6.0 or was it a 6.2 in my 2000 GMC three quarter ton cab and a half pickup. I pulled a lot of 14800 lb trailers with that and it just did not have the power. It had a 373 rear end but...
Forum: Formula
08-17-2019, 03:30 PM
Replies: 25
Views: 1,794
Posted By drumerjb

I agree on the 2500 but small V8 just doesn't do...

I agree on the 2500 but small V8 just doesn't do it. It's tolerable to put it politely.
Forum: Formula
08-16-2019, 10:33 PM
Replies: 25
Views: 1,794
Posted By drumerjb

Don't waste your time unless you're going, Mia 10...

Don't waste your time unless you're going, Mia 10 miles. It's good for that but nothing but frustration thereafter.
You need 3/4 ton diesel anything else is not fit for the pull.
08-04-2019, 11:42 PM
Replies: 0
Views: 363
Posted By drumerjb

Bravo 3 Prop Shafts .045 & .025

Boat has 250 hours on it, it is a 2006 formula 28 SS.
I have a vibration so I went to time my bravo 3 props, and check run out on shafts before sending props out for checkup and balancing. Found...
07-21-2019, 10:56 PM
Replies: 5
Views: 676
Posted By drumerjb

Can be heated and straightened and repaired....

Can be heated and straightened and repaired. YouTube.
07-17-2019, 10:09 PM
Replies: 16
Views: 2,599
Posted By drumerjb

What do you have it valued at?

What do you have it valued at?
06-15-2019, 12:00 AM
Replies: 2
Views: 602
Posted By drumerjb

Very cool event. I Wana do a Formula one. Looks...

Very cool event. I Wana do a Formula one. Looks like fun. Where is this event?
06-04-2019, 06:48 PM
Replies: 13
Views: 2,163
Posted By drumerjb

Thank thank you for the clarification it is...

Thank thank you for the clarification it is appreciated 🙃
06-04-2019, 11:33 AM
Replies: 13
Views: 2,163
Posted By drumerjb

Do you have the kit #. Can I just buy the right...

Do you have the kit #. Can I just buy the right impeller or is it not sold separately?
Do you sell this item. Give me a phone #.
06-04-2019, 01:02 AM
Replies: 13
Views: 2,163
Posted By drumerjb

So a stock quicksilver impeller won't work in my...

So a stock quicksilver impeller won't work in my brass stainless drop plate application?
06-04-2019, 12:58 AM
Replies: 13
Views: 2,163
Posted By drumerjb

I also m dealing with this. I replaced both...

I also m dealing with this. I replaced both impellers with Merc quicksilver. I noticed when @ West m they had an OEM & a ???. I could easily notice the West marine after market brand was a much...
Forum: General Q & A
06-02-2019, 08:03 PM
Replies: 5
Views: 256
Posted By drumerjb

Just replaced both impellers with quick silvers....

Just replaced both impellers with quick silvers. Brass housing wear surfaces had a slight waviness to them. Had the boat out 3 times last fall. From what I remember it always ran 170. Now it was...
Forum: General Q & A
06-02-2019, 07:51 AM
Replies: 5
Views: 256
Posted By drumerjb

I m running 160-180

I m running 160-180
Forum: General Q & A
06-01-2019, 10:07 PM
Replies: 5
Views: 256
Posted By drumerjb

Temps

What should my 2006 350 mag be running for cooling temps on average?
06-01-2019, 09:19 PM
Replies: 21
Views: 2,188
Posted By drumerjb

Who's responsible for tree logs

So we're a mile out from main gap harbor entrance Milwaukee River and I see a 20 foot by one foot in diameter tree log bobbing between the 2 foot waves.
So I get on the ship to shore and call milw...
05-29-2019, 12:14 AM
Replies: 3
Views: 300
Posted By drumerjb

Now that makes sense

Now that makes sense
05-28-2019, 11:38 PM
Replies: 3
Views: 300
Posted By drumerjb

Xs 2, & still don't know why mine doesn t work...

Xs 2, & still don't know why mine doesn t work either.
Forum: General Q & A
05-27-2019, 12:43 PM
Replies: 11
Views: 894
Posted By drumerjb

When I went to buy the new impeller at West...

When I went to buy the new impeller at West Marine here in Milwaukee the retail sales person said he had already sold six impellers that morning.
Forum: General Q & A
05-27-2019, 12:35 PM
Replies: 91
Views: 7,152
Posted By drumerjb

So I'm going through sea water pump issues right...

So I'm going through sea water pump issues right now with my boat and I thought I'd re resurrect this thread it's a great thread and has a lot of good information on it.
as far as commenting on...
Forum: General Q & A
05-26-2019, 11:15 AM
Replies: 11
Views: 894
Posted By drumerjb

Yeah, supposedly the pumps had been replaced just...

Yeah, supposedly the pumps had been replaced just prior of my purchase. Didn't know about brass housings thought they were all cast steel.
As far as that style muff goes if they don't leak and you...
Showing results 1 to 25 of 113
 


 
Forum Jump

OSO Sponsor
OSO Advertiser
OSO Advertiser
OSO Advertiser
OSO Advertiser
OSO Advertiser
OSO Advertiser