Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: articfriends
Showing results 1 to 20 of 20
Search took 0.01 seconds.
Forum: General Q & A
06-23-2020, 12:27 PM
Replies: 5
Views: 212
Posted By articfriends

do you still have air horn on it? Ive seen guys...

do you still have air horn on it? Ive seen guys take that off completely and just hose clamp screen over inlet
06-22-2020, 06:14 AM
Replies: 25
Views: 1,048
Posted By articfriends

If you want to go ten mph faster, going to...

If you want to go ten mph faster, going to needapproximately 200 more hp. Go thru motor mod everything, add a supercharger and you'll be there. There is no "easy or cheap" mods that will give you...
06-18-2020, 01:29 PM
Replies: 12
Views: 492
Posted By articfriends

I ordered a set of bills eickert/thunder and...

I ordered a set of bills eickert/thunder and lightning manifolds to do dyno testing!
Forum: General Q & A
06-16-2020, 12:59 PM
Replies: 7
Views: 766
Posted By articfriends

Ever buy this and run it? Does it have provision...

Ever buy this and run it? Does it have provision for gm.flex fuel sensor, still planning my personal 13-1 548s for my boat (E-85)
06-15-2020, 01:32 PM
Replies: 2
Views: 338
Posted By articfriends

The 6l80 is one of the newer transmissions that...

The 6l80 is one of the newer transmissions that DOESNT have a 1-1 gear somewhere BUT forth gear is close at 1.15. Currently in 6th gear (.67-1) it turns your 3.08 into 2.06 -1 final drive. A 4.56 x...
Forum: General Q & A
06-11-2020, 06:30 AM
Replies: 6
Views: 644
Posted By articfriends

Having dealt with this exact issue in past, i...

Having dealt with this exact issue in past, i will say at some point in your operating rpm, tune is lean or rich and hurt ring seal. On top of fact IF you still have original 4.466 bore je 700...
Forum: General Q & A
06-05-2020, 06:50 AM
Replies: 5
Views: 370
Posted By articfriends

Is that fuel pressure when running in water or...

Is that fuel pressure when running in water or when running on a hose, big difference as to the volume it needs
Forum: General Q & A
06-05-2020, 06:47 AM
Replies: 11
Views: 590
Posted By articfriends

If your gauge is correct your fuel pressure is...

If your gauge is correct your fuel pressure is low. Since both motors are the same and low (in 20s running is unacceptable) , Id be suspicious of gauge. Id run clean fuel, cleaner etc thru fuel...
Forum: General Q & A
06-03-2020, 01:33 PM
Replies: 8
Views: 482
Posted By articfriends

I have a test set coming from one of my injectors...

I have a test set coming from one of my injectors suppliers to flow against known good ones then test in boats, we'll see soon!
Forum: General Q & A
06-01-2020, 07:43 AM
Replies: 18
Views: 942
Posted By articfriends

I see this on my dyno with 10 o2 sensors all the...

I see this on my dyno with 10 o2 sensors all the time, victor junior, super victor and dart intakes are no exception either. When I dyno tune a MEFI engine I also see over 2 points afr spread from...
Forum: General Q & A
05-30-2020, 08:48 AM
Replies: 18
Views: 942
Posted By articfriends

When I dynoed my 462 cu inch pontiac in my...

When I dynoed my 462 cu inch pontiac in my transam, we saw 580 ish hp, with k/n 3 x 9 we saw a 40 plus hp loss and map reading at manifold went from 97.5 to sub 95 , closer to 94
Forum: General Q & A
05-28-2020, 07:20 AM
Replies: 5
Views: 377
Posted By articfriends

Ive consistently seen 10+ hp gain when running a...

Ive consistently seen 10+ hp gain when running a good ignition box on the dyno vs none in back to back testing. had alot of problems with ignition boxes on a supercharged 540 I had in a boat. because...
Forum: General Q & A
05-18-2020, 07:03 PM
Replies: 87
Views: 5,867
Posted By articfriends

Ive never seen a factory single roller chain that...

Ive never seen a factory single roller chain that DIDNT look loose as Fuk, thats pretty normal for these.
Forum: General Q & A
05-17-2020, 07:28 AM
Replies: 11
Views: 543
Posted By articfriends

Received your injectors, looking forward to...

Received your injectors, looking forward to working for you, Smitty
Forum: General Q & A
05-15-2020, 04:43 PM
Replies: 87
Views: 5,867
Posted By articfriends

Just watched it on.my phone, sounds like a lifter...

Just watched it on.my phone, sounds like a lifter or valve spring, the key is the noise will be at half the crankshaft speed if its in top end
Forum: General Q & A
05-13-2020, 09:28 AM
Replies: 11
Views: 543
Posted By articfriends

Yes, your motors are 23 years old and have...

Yes, your motors are 23 years old and have probably NEVER had injectors serviced. Pull plenum tops, gently unplug all injector plugs, unbolt the rails and work them out of place. Make sure everything...
Forum: General Q & A
05-12-2020, 11:21 AM
Replies: 32
Views: 1,098
Posted By articfriends

I dont think your IAC is necesarrily bad, I think...

I dont think your IAC is necesarrily bad, I think when its warm it has no control as its in its "minimum position" (unless its NOT cycling as far as it should). When its cold, it needs MORE air which...
Forum: General Q & A
05-06-2020, 10:55 AM
Replies: 3
Views: 357
Posted By articfriends

They need work, as cast they are barely better...

They need work, as cast they are barely better than stock,Id buy the EQs over them fwiw
Forum: General Q & A
04-27-2020, 06:18 AM
Replies: 27
Views: 1,766
Posted By articfriends

have injectors flowed and cleaned, call it good ....

have injectors flowed and cleaned, call it good . I see injectors that flow low from these 20+ year old motors when I do them and hear/ see horror story's of melted pistons , lost seasons, etc. Smitty
Forum: General Q & A
04-19-2007, 01:20 AM
Replies: 49
Views: 46,440
Posted By articfriends

Tyler crockett set mine as close to 11.5 as...

Tyler crockett set mine as close to 11.5 as possible under boost,12.5-13.1 cruising not in boost. On dyno with cmi dry headers motor was set anywhere from 11.2 to 11.8 under boost (trying for 11.5...
Showing results 1 to 20 of 20


 
Forum Jump

OSO Sponsor
OSO Advertiser
OSO Advertiser
OSO Advertiser
OSO Advertiser
OSO Advertiser

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

OSO Advertiser