Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: SabrToothSqrl
Showing results 1 to 25 of 500
Search took 0.02 seconds.
08-08-2022, 01:04 PM
Replies: 21
Views: 884
Posted By SabrToothSqrl

are the engines actually over heating? water...

are the engines actually over heating? water provides 100s of times more cooling than air can.

I've considered the above, making it out of an old cooler I don't use, or buckets work too. for...
Forum: General Q & A
08-02-2022, 07:36 PM
Replies: 18
Views: 700
Posted By SabrToothSqrl

My previous boat didn't have tabs, my Formula 292...

My previous boat didn't have tabs, my Formula 292 (stepped hull) does, so I LOVE being able to use them. When I have more than 1/2 tank or if I have 4 people on board, I'll drop the tabs to get on...
Forum: Formula
07-31-2022, 06:45 PM
Replies: 7
Views: 303
Posted By SabrToothSqrl

i see glue on that one post, I had to do that to...

i see glue on that one post, I had to do that to mine too a year or so ago.
07-28-2022, 06:32 PM
Replies: 9
Views: 342
Posted By SabrToothSqrl

i'm no expert but they look like old bravo 1s to...

i'm no expert but they look like old bravo 1s to me.
Forum: Formula
07-27-2022, 09:10 PM
Replies: 7
Views: 303
Posted By SabrToothSqrl

if you find out, LMK. mine are white too.

if you find out, LMK. mine are white too.
07-25-2022, 01:11 PM
Replies: 36
Views: 1,389
Posted By SabrToothSqrl

3x300s = 900 HP, but twin 600s = 1200 Hp ;) ...

3x300s = 900 HP, but twin 600s = 1200 Hp ;)

which is more cost effective?
07-19-2022, 10:02 AM
Replies: 40
Views: 2,541
Posted By SabrToothSqrl

I've had to change course many, many times....

I've had to change course many, many times. Moving the wheel or throttles is significantly cheaper than a collision.

Keep in mind, even if you're 'correct' and the other vessel at fault, you will...
Forum: General Q & A
07-18-2022, 01:54 PM
Replies: 14
Views: 641
Posted By SabrToothSqrl

Other than possible weight issues, (if one engine...

Other than possible weight issues, (if one engine is much heavier the boat may lean) assuming same prop and drive on both - I'd say it's irrelevant.

At cruise, you match engine RPMs. (prop RPM)....
Forum: Electronics
07-14-2022, 06:55 AM
Replies: 12
Views: 568
Posted By SabrToothSqrl

Shame I didn't know this when I got mine, my...

Shame I didn't know this when I got mine, my 2001s. I'm a data nerd and would have loved this stuff.
I know it's a 23 year old engine (actually its 2). But I'm surprised no one aftermarket has made...
07-12-2022, 10:25 AM
Replies: 29
Views: 1,478
Posted By SabrToothSqrl

Very nice. If I didn't have a friend with a metal...

Very nice. If I didn't have a friend with a metal one already built, this was plan B.
Forum: General Q & A
07-07-2022, 09:51 AM
Replies: 14
Views: 648
Posted By SabrToothSqrl

I bought 2 new base 350s from them, and am very...

I bought 2 new base 350s from them, and am very happy with the overall experience.

I would use them again if I needed engines.
07-01-2022, 01:53 PM
Replies: 17
Views: 1,508
Posted By SabrToothSqrl

I feel like the 'shades' above the rear cleats...

I feel like the 'shades' above the rear cleats should move up/down power. Like, when you turn the engines on, they should close up and conceal the cleats.
Forum: General Q & A
06-24-2022, 12:55 PM
Replies: 12
Views: 540
Posted By SabrToothSqrl

If you connect 2 return lines to 1 to return to...

If you connect 2 return lines to 1 to return to the tank, is there a risk of gas being pushed from one engine, against the other? Not sure if it would become a problem, but thinking 1 line per engine...
Forum: General Q & A
06-22-2022, 10:12 AM
Replies: 4
Views: 202
Posted By SabrToothSqrl

fancy. ...

fancy.

https://www.perko.com/catalog/category/marinium/
Forum: General Q & A
06-22-2022, 09:42 AM
Replies: 4
Views: 202
Posted By SabrToothSqrl

what is the word on it? Mariuium ? if you...

what is the word on it? Mariuium ?

if you remove it, are there any labels on the back side?

It really looks like you could just replace the bulb.
...
06-17-2022, 04:34 PM
Replies: 18
Views: 557
Posted By SabrToothSqrl

I have twin 350s, 2001, MEFI 3 as well. I did...

I have twin 350s, 2001, MEFI 3 as well.
I did new fuel pumps, coolers, and pressure regulators. Solved a lot of my similar issues. it's a hassle to get all that off in the hull, so I just did 'all...
06-15-2022, 05:08 PM
Replies: 14
Views: 612
Posted By SabrToothSqrl

Found my old thread: Bravo One Pivot Pin Thread...

Found my old thread: Bravo One Pivot Pin Thread Repaired (http://formulaboatsforum.com/VBFORUM/showthread.php?8597-Bravo-One-Pivot-Pin-Thread-Repaired&highlight=helicoil)
06-15-2022, 05:07 PM
Replies: 14
Views: 612
Posted By SabrToothSqrl

I had one of those pins strip out. I drilled it,...

I had one of those pins strip out. I drilled it, tapped it, and used stainless thread. It's been holding to the (I think 50 ft lb spec) for at least 5 years now just fine.

I don't recall the size...
06-09-2022, 09:00 AM
Replies: 2
Views: 366
Posted By SabrToothSqrl

It shouldn't be that difficult with the engine...

It shouldn't be that difficult with the engine out.
I did the JR fix on both of my drives as I didn't want to have to pull both engines. 4 years ago. It still seems fine to me.

I highly doubt...
Forum: General Q & A
06-05-2022, 08:03 PM
Replies: 5
Views: 372
Posted By SabrToothSqrl

I've not seen a 2 pump system, but I'm willing to...

I've not seen a 2 pump system, but I'm willing to follow along. try to help.
I installed imco external uni-mount on my 292, but it runs only off 1 engine's pump. (twin engine boat).

I assume...
06-01-2022, 05:46 PM
Replies: 4
Views: 1,308
Posted By SabrToothSqrl

Assuming you have a higher $ car, paid off, my...

Assuming you have a higher $ car, paid off, my credit union let's me take a low rate loan on it, up to KBB.

But yes, usually for older boat's you're looking at the options above.

my credit...
Forum: General Q & A
06-01-2022, 05:44 PM
Replies: 14
Views: 624
Posted By SabrToothSqrl

That sure is an interesting attachment plate....

That sure is an interesting attachment plate. Knowing nothing other than having installed my own 2 years ago, I would think the correct placement is to put the ram dead center of it's travel.

but...
05-26-2022, 07:39 AM
Replies: 12
Views: 903
Posted By SabrToothSqrl

I've not really seen any build up on an inboard...

I've not really seen any build up on an inboard boat engine. I run in salt water and have had several boats, and the engine bay is (of a well working boat) usually spotless. a PWC engine is much...
05-25-2022, 08:34 PM
Replies: 22
Views: 1,860
Posted By SabrToothSqrl

Ohh to be 20 again. ...

Ohh to be 20 again.

https://www.youtube.com/watch?v=obGrGGIoBdE
05-18-2022, 07:56 AM
Replies: 22
Views: 1,860
Posted By SabrToothSqrl

NICE! can you get us some photos? With that...

NICE! can you get us some photos?
With that engine/drive, you should be doing 90! My 460 would grace 60 MPH on a good day.

This is mine from long ago. I sold it back in 2017 I think. Had the boat...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.