Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: ajd0421
Showing results 1 to 14 of 14
Search took 0.00 seconds; generated 43 minute(s) ago.
Forum: Formula
04-18-2007, 08:03 AM
Replies: 9
Views: 2,435
Posted By ajd0421

I do have pics can email them to you. This boat...

I do have pics can email them to you. This boat has been in the water for a ride just a couple weeks ago. Runs great. Does need some TLC. Mostly just a good cleaning in the bildge. She sits on a...
Forum: Formula
04-17-2007, 05:33 PM
Replies: 9
Views: 2,435
Posted By ajd0421

'84 402 SR-1 must sell $39,000

The exterior gelcoat is in great condition. only a small scratched area, rear starboard side of hull, where boat may have bumped dock. The upholstery within the cabin is in excellent condition blue...
Forum: Formula
06-05-2005, 11:01 PM
Replies: 0
Views: 1,024
Posted By ajd0421

Gonna sell my '84 402 SR-1

I have a 1984 402 SR-1, twin 454 .040 over( est 525hp) 20 hrs on rebuild, Kaama drives, Stainless clevers, elec. head, Lectra-san, FWC, original blue & white suade interior is perfect, burl wood,...
Forum: Formula
08-18-2003, 10:56 AM
Replies: 1
Views: 5,466
Posted By ajd0421

KAAMA parts - Team Archer Marine

UPDATE----Team Archer is still alive and kicking in Costa Mesa, CA. I did finally get a hold of them by phone at 949-646-9778.

Aparently they were having some trouble with their phone system last...
Forum: Formula
07-26-2003, 12:52 PM
Replies: 22
Views: 6,357
Posted By ajd0421

When it's good, It's GREAT!!! only problem is...

When it's good, It's GREAT!!! only problem is that the good times don't last long enough... I have had the boat in the water 4 times and each time something else goes T.U.

R&R'ed the trans. Had...
Forum: Formula
07-18-2003, 01:18 PM
Replies: 22
Views: 6,357
Posted By ajd0421

Yeah, I thought I would slather it with plenty of...

Yeah, I thought I would slather it with plenty of 5200. Also considering drilling down through the top of the stringer and filling it with epoxy. the stringer is already water-logged and beginning...
Forum: Formula
07-18-2003, 10:08 AM
Replies: 22
Views: 6,357
Posted By ajd0421

It did come with a nice trailer. It recently had...

It did come with a nice trailer. It recently had new brakes, master cylinder, and bearings.

Yesterday I pulled the port engine/tranny, to find some scary stuff... White Marine of Portland, Or....
Forum: General Q & A
07-14-2003, 09:42 PM
Replies: 5
Views: 6,359
Posted By ajd0421

I have experienced a simular condition that took...

I have experienced a simular condition that took me a long time to diagnose. It was a poor electrical connection/low voltage to the pos side of the coil.

It's an easy test. With a volt meter,...
Forum: General Q & A
07-13-2003, 06:36 PM
Replies: 9
Views: 3,041
Posted By ajd0421

Thanks I have spoken to John Connor. He referred...

Thanks I have spoken to John Connor. He referred me to Team Archer Marine in S. Cal. Tried to call got recording # disconnected
Forum: General Q & A
07-13-2003, 12:08 PM
Replies: 9
Views: 3,041
Posted By ajd0421

I have posted a few pics of the boat that I took...

I have posted a few pics of the boat that I took before I bought it. Check them out at http://photos.yahoo.com/ajd0421 . I have only made one trial run so far and did not have GPS on board that day,...
Forum: Formula
07-13-2003, 11:54 AM
Replies: 22
Views: 6,357
Posted By ajd0421

I have posted a few pics of the boat that I took...

I have posted a few pics of the boat that I took before I bought it. Check them out at http://photos.yahoo.com/ajd0421 . I have only made one trial run so far and did not have GPS on board that...
Forum: Formula
07-11-2003, 01:47 AM
Replies: 22
Views: 6,357
Posted By ajd0421

Wink 402 Kaama

I bought the boat that there was a post about here 2 weeks ago. Boat was on www.traderonline, in Portland, Or. area. Was asking $43,900. ...
Forum: General Q & A
07-09-2003, 12:55 PM
Replies: 9
Views: 3,041
Posted By ajd0421

Who has parts for KAAMA Drives?

Who has parts for KAAMA Drives? I recently purchased a 1983 Formula 402 SR-1, with 454s, Twindisc MG-502 transmissions, KAAMA Surface Drives, and Clever Props. Nobody that I have spoken to knows...
Forum: General Q & A
07-08-2003, 10:09 AM
Replies: 1
Views: 1,910
Posted By ajd0421

KAAMA Surface Drives, I need help

I recently purchased a 1983 Formula 402 SR-1, with 454s, Twindisc MG-502 transmissions, KAAMA Surface Drives, and Clever Props. I need to R&R the portside trans. It blew on Sea trial. Now it's a...
Showing results 1 to 14 of 14


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.