New Engine Installed
#1
Finished the install of freshened 502 Mag and sea trialed the boat today.
Conditions: 38 Degrees, light snow!!!!!
Boat ran great, took it easy on the new engine but was seeing mid 60's at low - mid 4K Rpms. Boat should be a low - mid 70's boat for a new owner.
All tie wraps and cush clamps were replaced. Any holes oin the bilge were repaired and touched up with Awlgrip paint. All loose wires were properly wrapped and secured.
Here are pictures of the installation:
Conditions: 38 Degrees, light snow!!!!!
Boat ran great, took it easy on the new engine but was seeing mid 60's at low - mid 4K Rpms. Boat should be a low - mid 70's boat for a new owner.
All tie wraps and cush clamps were replaced. Any holes oin the bilge were repaired and touched up with Awlgrip paint. All loose wires were properly wrapped and secured.
Here are pictures of the installation:
Thread
Thread Starter
Forum
Replies
Last Post
powerguy
General Q & A
8
03-16-2002 05:49 AM





