Transducer removal
08-29-2005 | 09:05 AM
#1
Thread Starter
Registered
Joined: Feb 2005
Posts: 2
Likes: 0
Transducer removal
Looking for advice on removing a Thru Hull transducer. Have replacement (came with an epoxy), need to get old one out.
Looks like there is only one area in the bilge with a "pocket" for a transducer, so I probably need to use same location.
Looks like there is only one area in the bilge with a "pocket" for a transducer, so I probably need to use same location.
09-06-2005 | 11:06 AM
#2
Thread Starter
Registered
Joined: Feb 2005
Posts: 2
Likes: 0
Re: Transducer removal
Ok, answered my own question...nothing a small prybar couldn't take care of...popped right out w/ a little pressure.
Worst part was rerouting the new t-ducer wires thru all the wire loom - Uggggh!
Worst part was rerouting the new t-ducer wires thru all the wire loom - Uggggh!
