drive trim /pump dosen't work correct
#1
Thread Starter
Registered
Joined: Nov 2003
Posts: 791
Likes: 0
From: mass
a few weeks a ago my switch on the shifter stuck in the up position while at the beach.drives went down but could not go up.took all of your suggestions and i had blown the up solinoids on both.replaced them and works fine on the switch on the throttle.the problem now is they don't go up even on the single switch's push the portside up and both drives trim but if i go down only one drive goes down.
Thread
Thread Starter
Forum
Replies
Last Post
ratman
General Boating Discussion
5
01-26-2006 07:48 PM




