582" Short Block
07-20-2008, 08:34 PM
#1
Registered
Platinum MemberThread Starter
582" Short Block
I hava a new 582" short block ready for cam and assembly.
Pistons and rods have Dyno time. Crank is new, Rings are new and have new bearings. Don't remember if I installed Clevite H, or King Pro.
Block is Bowtie gen IV. Block was cooled by radiator it's whole life.
Been saving this short block for a special project that is not going to show up. Selling for less than the cost of the parts.
Cam, heads, intakes assembly, or finished engine available.
$4K for the short block plus shipping. Great deal for someone who wants a big inch, high HP engine.
I have had these engines to over 700HP with mild cams and 4150 flange carbs. There is more potential than that.
Pistons and rods have Dyno time. Crank is new, Rings are new and have new bearings. Don't remember if I installed Clevite H, or King Pro.
Block is Bowtie gen IV. Block was cooled by radiator it's whole life.
Been saving this short block for a special project that is not going to show up. Selling for less than the cost of the parts.
Cam, heads, intakes assembly, or finished engine available.
$4K for the short block plus shipping. Great deal for someone who wants a big inch, high HP engine.
I have had these engines to over 700HP with mild cams and 4150 flange carbs. There is more potential than that.
Thread
Thread Starter
Forum
Replies
Last Post
Rockfish71
General Q & A
4
05-29-2008 01:39 PM
chrisf
General Boating Discussion
8
01-13-2006 04:44 PM
Dregsz
General Q & A
0
06-25-2005 12:26 AM
