I have a Volvo 250 set up that was taken out of a boat a few years ago due to a cracked engine block.

Drive, Transom assembly, bell housing for a ford engine. and the tilt assembly.

This is a ford bell housing that is a low profile version which allows for a windsor motor to fit in a 16' without cutting into the seat. This was really hard to find and is quite valuable to a Donzi / volvo / Ford fan. It could easily be swapped out for a GM version.

2 props
stainless 21"
al 23"

Drive had the performance tip added to the bullet

I am looking to get rid of everything quick. The first reasonable offer gets it.

Dave
860 944 1210
[email protected]