what is the most comming prop diameter that people run on a 32 skater with #6's , im running 16.5 is that to much ? i dont have alot of knowledge with this set up . does anybody run 17's??? any info should be great .

I'm running 16.25 merc cnc's

should i try 17's???

NOPE & call Leon D he'll set ya str8, he ran the boat at almost 170 mph ..dont listen to the dork you bought it from he could'nt get it over 105
good luck

wow thanks ! i just got the boat back today with new motors , from innovation , 30.000 later , the boats on the limiters hard with 34's with 150 gear ratios at 6200.
now the trandsmission or the tail stock is spitting oil everywhere , the drives gotta come off , to pull the tail stock ? sucks ... i talked to leon , super nice guy. so sick of this ****

so excited to finally run this thing and oils everywhere in the bilge .. so sick of this ****

its on the limiters so hard , im gonna need a set of 38's
the boat was advertised with 37 5 blades ????, and when i picked it up , it had 34 four blades?

the guy you bought it from is a CR@@K , wish you had asked some ??? b4 Bro and could of saved you some $$$ and a ton of grief ..Leon knows that boat like the back of his hand and great guy ..

anybody got a set of 38's i can try ?

Randy at Marine drives in Inglis fl can take care of either for you .. Marine Drive Services is located at Mary St Inglis, FL. Phone: 352-447-0309


shoot me a pm with your # and i'll give ya a shout 2morrow