Good running 454 Mark IV 330 horse BBC 4 bolt mains
#1
Thread Starter
Registered
Joined: Aug 2007
Posts: 266
Likes: 4
From: Port Deposit, MD
Hi everyone,
I have a nice good running ready to go 454 Mark IV 330 horse motor with a 4 bolt main block. Motor came out of our Scarab when we repowered. Used no oil and ran well. No idea on the hours but it isnt a ton. Pulled the oil pan and bearings looked good so we buttoned her back up. Complete intake to pan. Has the nicer Merc dual plane aluminum intake used on the mag motors. Has Holley mechanical fuel pump on it, add your carb ignition accessories and exhaust and your back on the water. Has the finned aluminum Merc style oil pan. Looking for $2,000. Also have some other BBC marine parts.
Thanks,
Brad Harbold
410-688-3798
I have a nice good running ready to go 454 Mark IV 330 horse motor with a 4 bolt main block. Motor came out of our Scarab when we repowered. Used no oil and ran well. No idea on the hours but it isnt a ton. Pulled the oil pan and bearings looked good so we buttoned her back up. Complete intake to pan. Has the nicer Merc dual plane aluminum intake used on the mag motors. Has Holley mechanical fuel pump on it, add your carb ignition accessories and exhaust and your back on the water. Has the finned aluminum Merc style oil pan. Looking for $2,000. Also have some other BBC marine parts.
Thanks,
Brad Harbold
410-688-3798
#8
Registered
Joined: Jul 2011
Posts: 2
Likes: 0
From: Ventura, CA
I am interested in your engine for my Sea Ray Sundancer.
Would it be possible to ship the engine to California? If so, what do you think the cost would be? My zip code is 93004.
If you were to guess at the hours on the engine, what is your best guess?
Thanks
Would it be possible to ship the engine to California? If so, what do you think the cost would be? My zip code is 93004.
If you were to guess at the hours on the engine, what is your best guess?
Thanks
#9
Thread Starter
Registered
Joined: Aug 2007
Posts: 266
Likes: 4
From: Port Deposit, MD
Ron, I have no idea the hours, doubt its alot. Pulled the pan and checked bearings, they look good. Has good compression and it runs well and uses no oil. Other than that I dont know what to tell you. I am willing to paletize it so it can be shipped. Not sure what that would costs. To give you an idea it was like $450 to TX so certainly more than that.
Thanks,
Brad
Thanks,
Brad
#10
Nice looking apache you have there! This is the guy with the blue panther that look like your scarab 2. We've BS at the port deposit ramp before. When we going to see the apache on the water? Also I know a guy that would love your scarab but its over his budget. Do you have any room to move there?




