anyone have a pair of 1" or 1 1/2" spacers they want to get rid of that will fit a bravo X drive?

Thanks

I have one 1" that has a hour of test time on it

I also have (2)1" Bravo spacers that need to go, only one will fit a normal Bravo, the other is machined to fit over the special Max Machine worx full tower so Pm me if you need one, Smitty
They both have less than a hour test time

I have a pair of 2" spacers that you could machine down.

I have a pair of 1" I used on my XRs, make an offer


Shawn

what condition are they in, who makes them, and how much do you want for them. I think they will be to big but might be worth trying out depending on the price.

I sent a pm to everyone else who replied.

Thanks.

I've got some 1.5" that I will sell.

can you pm me with price and info? thx

whacha want erik ? boxem up you have my adress

So i measured the boat and the bottom of my cavitation plates are 1 7/8" above the bottom of the chine directly in front of the drive. I think that a 1 1/2" spacer will be the right one for as 2" will be to low and 1" won't get me low enough. anyone have any suggestions? Still looking for a set of 1 1/2" spacers.