What is this pics included
04-23-2012 | 09:03 PM
#2
Ginger or Mary Ann?
Joined: Oct 2000
Posts: 11,030
Likes: 9
From: L
Is it plastic or a zinc? Wires on inside mounting bolts connected to motors?
__________________
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
04-23-2012 | 09:40 PM
#4
Gold Member
Joined: Jan 2001
Posts: 2,123
Likes: 1
From: Brooklyn Park, Md USA
Its an Anode and should be replaced when it gets a crust covering it. As said it should have a bonding wire on the inside of the boat running to a ground either on a stud at a bell housing or right to a battery.
04-23-2012 | 10:09 PM
#7
Registered
Joined: Jan 2010
Posts: 53
Likes: 0
From: Iowa
04-23-2012 | 10:54 PM
#9
Ginger or Mary Ann?
Joined: Oct 2000
Posts: 11,030
Likes: 9
From: L
Best to go to engine block on back where all your ground wires connect to the bell housing stud. All ground/bonding wires should really go to 1 single connection point.
__________________
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
Last edited by US1 Fountain; 04-23-2012 at 10:56 PM.
04-23-2012 | 11:16 PM
#10
Gold Member
Joined: Jan 2001
Posts: 2,123
Likes: 1
From: Brooklyn Park, Md USA
