I'm considering 28 cleavers 15 inch but nor sure if its too much. The left engine is sitting on the limiter at 7200 w 24 lightning ets but right engine only getting 6600 w the same 24. Think it needs some work.

Ill check mine later? Damn memory loss!

Ok I've ordered one 28p chopper for the left engine thats sitting on the limiter at 7200. Hopefully we'll see how it runs in the next few days.

If your bumping the limiter, get them pitched higher.

I run 28 coppers on my Awesomecat at 6500 rpms.

You need alot of head wind to get her to air out.

Mine is dead in the water without a good wind.

But, the choppers are the way to go
Engine height is very important.

High as possible without losing water pressure.
I run transom pick ups which is the best way to keep your water pressure.Also have low water pick up "both"

Just me 2 cents