525EFI Lifters, Spark Plug Wire Sets, Custom Tuned PCM 555, and Bravo XR Prop Shaft
08-29-2012 | 06:57 PM
#1
Thread Starter
Registered
Joined: Aug 2010
Posts: 65
Likes: 0
525EFI Lifters, Spark Plug Wire Sets, Custom Tuned PCM 555, and Bravo XR Prop Shaft
525 EFI lifters: Two Sets (32 total), stock lifters, aprrox 200hours, most of it is idling, good condition and nothing was wrong, replaced them with Morel because I removed the limiters and planned on doing a lot of high rpm running to test drive spacers and props.
Spark Plug Wire Sets: Two new sets of wire harnesses. Never ran ordered the wrong ones. The coil packs must be in the center of the engine for these to work.
Custom Tuned PCM 555s: Two PCM555 computers tuned by Precision Marine for 93 Octane and 5800 rpm limit.
Bravo XR 1.25” HD Prop Shaft: Adding bigger power and replaced with Teague.
I can take pictures of any of these if needed.
Spark Plug Wire Sets: Two new sets of wire harnesses. Never ran ordered the wrong ones. The coil packs must be in the center of the engine for these to work.
Custom Tuned PCM 555s: Two PCM555 computers tuned by Precision Marine for 93 Octane and 5800 rpm limit.
Bravo XR 1.25” HD Prop Shaft: Adding bigger power and replaced with Teague.
I can take pictures of any of these if needed.
09-12-2012 | 02:31 PM
#6
Thread Starter
Registered
Joined: Aug 2010
Posts: 65
Likes: 0
Sorry for the delay guys I have been traveling.
UPDATE:
The propshaft is sold.
I think 500 for both sets of lifters is fair.
I would only like to sell the pcm as a set right now. Maybe split in the future. Just to confirm you would have to exchange your exsisting pcm.
UPDATE:
The propshaft is sold.
I think 500 for both sets of lifters is fair.
I would only like to sell the pcm as a set right now. Maybe split in the future. Just to confirm you would have to exchange your exsisting pcm.
