Good morning all, I have a 30'flat deck scarab project that has been indoors since 03, the engines were winterized / fogged at that time, the engines have been turned by hand 3/4 times a year 8-10 revolutions, I removed the plugs 2 years ago squirted oil in the cylinders and rolled the engines with the starters to build oil pressure and reinstalled the plugs, they are built small blocks,(Myles engineering back in the day) world heads, roller rockers stud girdles weiand intakes holley carbs, and 10 quart pans,(internals unknown,sounded healthy) it has Gil magnum sport manifolds and Mercury racing stainless mufflers/ tips, both gimble housings/ transom assys were replaced with good non welded up junk,new shafts seals etc as necessary both trs drives were gone through,new u joints, media blasted and repainted, it has mercruiuser II electric shift transmissions, the original interior was replaced a year or two before I purchased it and is still decent (stored in closets in house), ...the bad... the main stringers are all shot, the floor has been removed to access/ repair, cut in a way it can be reinstalled following repairs..I would prefer to sell it whole for 8.5k but will part if engines sell, also have a 2000 tri axle 10,000 lb trailer available if boat parts./sells If anyone has an interest please call (phonetic spelling) four one nine 433 six nine 8 three, eves and ask for Jim ,Thank you

Pics to [email protected]

Where are you located?

Pics to [email protected]

Guys Thanks for the interest, I will get some photos this weekend to all that sent me an e mail address again Thanks Regards Jim

Thanks again Guys , photos sent Sun am, if there is something in particular you want more details of give me a call,Regards Jim

77 30' scarab project/parts prefer to sell all
Greetings again all, I found I could not edit my previous post (typical noob mistake) so I have relisted it with the changes,what I have is, a 30'flat deck scarab project that has been indoors since 03,it is sitting on a 2000 12000# tri axle aluminum trailer, the engines were winterized / fogged at that time, the engines have been turned by hand 3/4 times a year 8-10 revolutions, I removed the plugs 2 years ago squirted oil in the cylinders and rolled the engines with the starters to build oil pressure and reinstalled the plugs, they are built small blocks,(Myles engineering back in the day) world heads, roller rockers, stud girdles, weiand intakes, holley carbs, and 10 quart pans,(internals unknown,sounded healthy) it has Gil magnum sport manifolds and Mercury racing stainless mufflers/ tips, both gimble housings/ transom assys were replaced with good (not welded up junk),units ,new shafts seals etc as necessary both trs drives were gone through,new u joints, media blasted and repainted, it has mercruiuser II electric shift transmissions, the original interior was replaced a year or two before I purchased it and is still decent (stored in closets in house), ...the bad... the main stringers are all shot, the floor has been removed to access/ repair, cut in a way it can be reinstalled following repairs..I would prefer to sell it whole for $7,500.(I do believe the sum total of the parts is far greater) if there is no interest in the whole,by Dec 1, I will be accepting offers for the parts If anyone has an interest please call (phonetic spelling) four one nine 433 six nine 8 three, eves and ask for Jim ,Thank you

Greetings all
For anyone interested, the scarab project that I listed in the swap shop is now on e-bay, it will show you pics of the parts , please excuse the layer of dust on everything (my lot in life) all the rebuilt/ replaced parts haven't seen water since being re done ,neither has the boat or trailer since 03, again if it goes unsold I will begin accepting offers on parts , Dec 1, Thanks for your interest, Regards Jim

I may be interested in the hull, can you shoot me a pm, Im local I think...