Does anyone have a spare spacer that goes between the crank pulley and blower drive pulley for a gilmer belt system on a procharger...or know where I can find one at? If someone could provide a part numer that would be great! Thanks, Mark

Do you know how thick it is? I assume it's the same spacer that is used on a standard 8mm pulley. If so, CP Performance has a variety of spacers in different thicknesses. The Blower Shop has them as well.
Eddie

Mark,

Give Alex a call at Haxby Speed, he will have what you need.

604.315.0570
778.340.7474

Bob

Thank you Eddie and Bob! I really appreciate the info. I'm having a hard time figuring out if I have the wrong pulley combo also. I haven't installed the procharger (it's a m3-sc) on the motor yet but am concerned that its going to produce more boost than I want with an 80 tooth crank pulley and a 42 tooth s/c pulley. Any thoughts on this? I have an email sent to both Steve Morris and brutespeed....but haven't heard back yet. I'm looking for about 6 pounds of boost (give or take). Thanks, Mark