Mercury racing plant tour
12-27-2013 | 04:42 PM
#1
Thread Starter
Registered
Joined: May 2010
Posts: 114
Likes: 0
From: Long Island,NY
Mercury racing plant tour
Found these thought I would share. Something to get us thru the winter.
Part 1 http://youtu.be/6k_TWsuvQ5c
Part2 http://youtu.be/BvlDmBb_6z4
Part 3 http://youtu.be/R7ojlLwxWRE
Part4 http://youtu.be/a_pcR4DrOok
Part 5 http://youtu.be/nyh_-11S988
Part 6 http://youtu.be/OJJsOY3mnSI
Might as well add this one too
http://youtu.be/Srs6boxae5o
Part 1 http://youtu.be/6k_TWsuvQ5c
Part2 http://youtu.be/BvlDmBb_6z4
Part 3 http://youtu.be/R7ojlLwxWRE
Part4 http://youtu.be/a_pcR4DrOok
Part 5 http://youtu.be/nyh_-11S988
Part 6 http://youtu.be/OJJsOY3mnSI
Might as well add this one too
http://youtu.be/Srs6boxae5o
Last edited by vbot24; 12-27-2013 at 04:48 PM.
12-28-2013 | 08:15 AM
#6
Registered
Joined: May 2012
Posts: 387
Likes: 5
From: SD-KS
Well in vid one, one answer came that I have not seen. PPG paint. That should make it easier to match.
Also, as a Sr Engineer, I did not like the tool used to install the main caps. Getting even torque is a simple one, but it allows the cap to rock back and forth on the way down when it should be seated in it's home first before the torque is applied. This is towards the end of vid one.
Also, as a Sr Engineer, I did not like the tool used to install the main caps. Getting even torque is a simple one, but it allows the cap to rock back and forth on the way down when it should be seated in it's home first before the torque is applied. This is towards the end of vid one.
Last edited by jvthundercat; 12-28-2013 at 08:20 AM.
